BIO_socket, BIO_bind, BIO_connect, BIO_listen, BIO_accept_ex, BIO_closesocket - BIO socket communication setup routines
#include <openssl/bio.h>
int BIO_socket(int domain, int socktype, int protocol, int options); int BIO_bind(int sock, const BIO_ADDR *addr, int options); int BIO_connect(int sock, const BIO_ADDR *addr, int options); int BIO_listen(int sock, const BIO_ADDR *addr, int options); int BIO_accept_ex(int accept_sock, BIO_ADDR *peer, int options); int BIO_closesocket(int sock);
BIO_socket() creates a socket in the domain domain, of type
socktype and protocol. Socket options are currently unused,
but is present for future use.
BIO_bind() binds the source address and service to a socket and
may be useful before calling BIO_connect(). The options may include
BIO_SOCK_REUSEADDR, which is described in FLAGS below.
BIO_connect() connects sock to the address and service given by
addr. Connection options may be zero or any combination of
BIO_SOCK_KEEPALIVE, BIO_SOCK_NONBLOCK and BIO_SOCK_NODELAY.
The flags are described in FLAGS below.
BIO_listen() has sock start listening on the address and service
given by addr. Connection options may be zero or any
combination of BIO_SOCK_KEEPALIVE, BIO_SOCK_NONBLOCK,
BIO_SOCK_NODELAY, BIO_SOCK_REUSEADDR and BIO_SOCK_V6_ONLY.
The flags are described in FLAGS below.
BIO_accept_ex() waits for an incoming connections on the given
socket accept_sock. When it gets a connection, the address and
port of the peer gets stored in peer if that one is non-NULL.
Accept options may be zero or BIO_SOCK_NONBLOCK, and is applied
on the accepted socket. The flags are described in FLAGS below.
BIO_closesocket() closes sock.
Enables regular sending of keep-alive messages.
Sets the socket to non-blocking mode.
Corresponds to TCP_NODELAY, and disables the Nagle algorithm. With this set, any data will be sent as soon as possible instead of being buffered until there's enough for the socket to send out in one go.
Try to reuse the address and port combination for a recently closed port.
When creating an IPv6 socket, make it only listen for IPv6 addresses and not IPv4 addresses mapped to IPv6.
These flags are bit flags, so they are to be combined with the
| operator, for example:
BIO_connect(sock, addr, BIO_SOCK_KEEPALIVE | BIO_SOCK_NONBLOCK);
BIO_socket() returns the socket number on success or INVALID_SOCKET
(-1) on error. When an error has occurred, the OpenSSL error stack
will hold the error data and errno has the system error.
BIO_bind(), BIO_connect() and BIO_listen() return 1 on success or 0 on error.
When an error has occurred, the OpenSSL error stack will hold the error
data and errno has the system error.
BIO_accept_ex() returns the accepted socket on success or
INVALID_SOCKET (-1) on error. When an error has occurred, the
OpenSSL error stack will hold the error data and errno has the system
error.
BIO_ADDR(3)
BIO_gethostname(), BIO_get_port(), BIO_get_host_ip(),
BIO_get_accept_socket() and BIO_accept() were deprecated in OpenSSL 1.1.0.
Use the functions described above instead.
Copyright 2016-2019 The OpenSSL Project Authors. All Rights Reserved.
Licensed under the OpenSSL license (the "License"). You may not use this file except in compliance with the License. You can obtain a copy in the file LICENSE in the source distribution or at https://www.openssl.org/source/license.html.