Add an orig_dgid attribute in sysfs for SRP scsi_hosts, so that
userspace can tell what the original dgid value written to the
add_target file was, even if the connection is redirected to a
different port while connecting.
Signed-off-by: Ishai Rabinovitz <ishai@mellanox.co.il>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
The IPoIB CM spec allows the use of a single connection in both
active->passive and passive->active directions. The current Linux
code uses one connection for both directions, but if another node only
uses one connection for both directions, we oops when we try to look
up the passive connection. Fix by checking that qp_context is
non-NULL before dereferencing it.
Signed-off-by: Michael S. Tsirkin <mst@dev.mellanox.co.il>
The HW now posts 2 ABORT_RPL and/or PEER_ABORT_REQ messages. We need
to handle them by silenty dropping the 1st but mark that we're ready
for the final message. This plugs some close races between the uP and
HW. Also update the minimum required firmware version.
Signed-off-by: Steve Wise <swise@opengridcomputing.com>
Signed-off-by: Roland Dreier <rolandd@cisco.com>
Some fixups for the R7785RP board. Gets iVDR working.
Signed-off-by: Ryusuke Sakato <sakato.ryusuke@renesas.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
With the shared APM emulation code being introduced, hp6xx was missed
in the conversion. Get it building again.
Signed-off-by: Kristoffer Ericson <kristoffer.ericson@gmail.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
hp6xx requires some additional IRQs that aren't currently enabled in
the SH7709 setup code. Wire them up.
Signed-off-by: Takashi YOSHII <takashi.yoshii.ze@hitachi.com>
Signed-off-by: Kristoffer Ericson <kristoffer.ericson@gmail.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
This adds more full-featured support for the SH7722 Solution Engine.
Previously this was using the generic board, and lacked most of the
peripheral support.
Signed-off-by: Ryusuke Sakato <sakato.ryusuke@renesas.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
With the addition of the R7780MP and R7785RP, the R7780RP build
ended up breaking. Trivial compile fix.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
Previously this was done in cpuinfo, but with the number of clocks
growing, it makes more sense to place this in a different proc entry.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
This fixes up SH7705 CPU support and the SE7705 board
for some of the recent changes.
Signed-off-by: Nobuhiro Iwamatsu <nobuhiro.iwamatsu.zh@hitachi.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
This adds the enable/disable hooks for the port clock to sh-sci.
Signed-off-by: dmitry pervushin <dimka@nomadgs.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
This adds support for the SH7722 (MobileR) to the clock framework.
Signed-off-by: dmitry pervushin <dimka@nomadgs.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
Drop the hd64461 I/O ops and wire up pata_platform for MMIO.
Signed-off-by: Kristoffer Ericson <Kristoffer_e1@hotmail.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
This wasn't being set before, so now it's set for when it makes sense.
The shwdt case still requires HZ to be fixed at 1000 for the WOVF period,
so this is still preserved.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
Add support for the SH7780 PCIC on the Solution Engine 7780,
missing from the previous board-support patch.
Signed-off-by: Nobuhiro Iwamatsu <nobuhiro.iwamatsu.zh@hitachi.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
This adds support for the SH7780-based Solution Engine reference board.
Signed-off-by: Nobuhiro Iwamatsu <nobuhiro.iwamatsu.zh@hitachi.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
Previously we've been handling udivdi3 references and wrapping
them in to div64_32() automatically. This doesn't get a lot of
use, however, and as akpm noted in the recent thread on l-k:
http://lkml.org/lkml/2007/2/27/241
we're better off simply ripping it out and going the do_div()
route if there happen to be any places that need it.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
This reworks some of the node 0 bootmem initialization in
preparation for discontigmem and sparsemem support.
ARCH_POPULATES_NODE_MAP is switched to as a result of this.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
This adds support for the L-BOX RE2 router.
http://www.nttcom.co.jp/l-box/
L-BOX RE2 is a SH7751R-based router. It has CF, Cardbus, serial,
and LAN x2. This is one of the very few SH boards that a general
person can obtain now.
The L-BOX shipped with a 2.4.28 kernel, this is a rewritten patch
adding it to current git.
Signed-off-by: Nobuhiro Iwamatsu <iwamatsu@nigauri.org>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
Updates for the landisk board:
- The push_switch framework was used.
- landisk_pwb.c was divided into psw.c and gio.c.
- pata_platform was supported in USL-5P.
- irq.c was rewritten.
- io.c was replaced with generic I/O routines.
Signed-off-by: kogiidena <kogiidena@eggplant.ddo.jp>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
Trivial compilation fixes for the hp6xx drivers.
Signed-off-by: Kristoffer Ericson <Kristoffer_e1@hotmail.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
With the GDB stub being entered via a special sysrq trigger,
we don't want to hit it directly from sci_br_interrupt().
Without this, there is access to the other sysrq triggers when
kgdb is enabled.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
This implements stricter and more compliant knightrider strobing in the
heartbeat handler. While there still seems to be some debate as to
whether the double 0 is "more" correct or not, this updated version
appears to have general consensus. Fixes a long-term "bug".
Signed-off-by: Takashi YOSHII <takashi.yoshii.ze@hitachi.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
This enables pata_platform support for the PCMCIA slot on the
SolutionEngine.
Signed-off-by: Nobuhiro Iwamatsu <hemamu@t-base.ne.jp>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
This adds preliminary support for the SH7785-based Highlander board.
Some of the Highlander support code is reordered so that most of it
can be reused directly.
This also plugs in missing SH7785 checks in the places that need it,
as this is the first board to support the CPU.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
Each board sets the total number of IRQs that it's interested in via
the machvec. Previously we cared about the off vs on-chip IRQ range,
but any code relying on that is long dead. Set NR_IRQS to something
sensible given the vector range, and allow boards to cap it if they
really care.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
Wire up GENERIC_BUG for SH. This moves off of the special bug
frame and on to the generic struct bug_entry. Roughly the same
semantics are retained, and we can kill off some of the verbose
BUG() reporting code.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
SH7780 has a speculative execution mode where it can speculatively
perform an instruction fetch for subroutine returns, this allows it
to be enabled. There are some various pitfalls associated with this
mode, so it's left as depending on CONFIG_EXPERIMENTAL and not
enabled by default.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
The kgdb thread support is woefully out of date (it predates
the pidhash), and needs a complete rewrite before it's useful
again. Just rip it out entirely.
Updating the unified kgdb stub is a more worthwhile endeavour
for anyone that happens to be interested in this, at present
it's just limping along.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
This code has suffered quite a bit of bitrot, do some basic
tidying to get it to a reasonably functional state again.
This gets the basic support and the console working again.
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
Add NFS lock support to GFS2.
Signed-off-by: Marc Eshel <eshel@almaden.ibm.com>
Signed-off-by: J. Bruce Fields <bfields@citi.umich.edu>
Acked-by: Steven Whitehouse <swhiteho@redhat.com>
Rewrite nlmsvc_lock() to use the asynchronous interface.
As with testlock, we answer nlm requests in nlmsvc_lock by first looking up
the block and then using the results we find in the block if B_QUEUED is
set, and calling vfs_lock_file() otherwise.
If this a new lock request and we get -EINPROGRESS return on a non-blocking
request then we defer the request.
Also modify nlmsvc_unlock() to call the filesystem method if appropriate.
Signed-off-by: Marc Eshel <eshel@almaden.ibm.com>
Signed-off-by: J. Bruce Fields <bfields@citi.umich.edu>
Normally we could skip ever having to allocate a block in the case where
the client asks for a non-blocking lock, or asks for a blocking lock that
succeeds immediately.
However we're going to want to always look up a block first in order to
check whether we're revisiting a deferred lock call, and to be prepared to
handle the case where the filesystem returns -EINPROGRESS--in that case we
want to make sure the lock we've given the filesystem is the one embedded
in the block that we'll use to track the deferred request.
Signed-off-by: Marc Eshel <eshel@almaden.ibm.com>
Signed-off-by: J. Bruce Fields <bfields@citi.umich.edu>
Rewrite nlmsvc_testlock() to use the new asynchronous interface: instead of
immediately doing a posix_test_lock(), we first look for a matching block.
If the subsequent test_lock returns anything other than -EINPROGRESS, we
then remove the block we've found and return the results.
If it returns -EINPROGRESS, then we defer the lock request.
In the case where the block we find in the first step has B_QUEUED set,
we bypass the vfs_test_lock entirely, instead using the block to decide how
to respond:
with nlm_lck_denied if B_TIMED_OUT is set.
with nlm_granted if B_GOT_CALLBACK is set.
by dropping if neither B_TIMED_OUT nor B_GOT_CALLBACK is set
Signed-off-by: Marc Eshel <eshel@almaden.ibm.com>
Signed-off-by: J. Bruce Fields <bfields@citi.umich.edu>
Change NLM internal interface to pass more information for test lock; we
need this to make sure the cookie information is pushed down to the place
where we do request deferral, which is handled for testlock by the
following patch.
Signed-off-by: Marc Eshel <eshel@almaden.ibm.com>
Signed-off-by: J. Bruce Fields <bfields@citi.umich.edu>
Add code to handle file system callback when the lock is finally granted.
Signed-off-by: Marc Eshel <eshel@almaden.ibm.com>
Signed-off-by: J. Bruce Fields <bfields@citi.umich.edu>
We need to keep some state for a pending asynchronous lock request, so this
patch adds that state to struct nlm_block.
This also adds a function which defers the request, by calling
rqstp->rq_chandle.defer and storing the resulting deferred request in a
nlm_block structure which we insert into lockd's global block list. That
new function isn't called yet, so it's dead code until a later patch.
Signed-off-by: Marc Eshel <eshel@almaden.ibm.com>
Signed-off-by: J. Bruce Fields <bfields@citi.umich.edu>
Acquiring a lock on a cluster filesystem may require communication with
remote hosts, and to avoid blocking lockd or nfsd threads during such
communication, we allow the results to be returned asynchronously.
When a ->lock() call needs to block, the file system will return
-EINPROGRESS, and then later return the results with a call to the
routine in the fl_grant field of the lock_manager_operations struct.
This differs from the case when ->lock returns -EAGAIN to a blocking
lock request; in that case, the filesystem calls fl_notify when the lock
is granted, and the caller retries the original lock. So while
fl_notify is merely a hint to the caller that it should retry, fl_grant
actually communicates the final result of the lock operation (with the
lock already acquired in the succesful case).
Therefore fl_grant takes a lock, a status and, for the test lock case, a
conflicting lock. We also allow fl_grant to return an error to the
filesystem, to handle the case where the fl_grant requests arrives after
the lock manager has already given up waiting for it.
Signed-off-by: Marc Eshel <eshel@almaden.ibm.com>
Signed-off-by: J. Bruce Fields <bfields@citi.umich.edu>
