This fixes the following build error with CONFIG_KEYS=n, caused by
commit dfd15c46a6 ("cifs: explicitly
revoke SPNEGO key after session setup"):
CC [M] fs/cifs/sess.o
fs/cifs/sess.c: In function 'CIFS_SessSetup':
fs/cifs/sess.c:628: error: implicit declaration of function 'key_revoke'
make[3]: *** [fs/cifs/sess.o] Error 1
Signed-off-by: Adrian Bunk <bunk@kernel.org>
Acked-by: Jeff Layton <jlayton@redhat.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Commit ed458df4d2 ("PnP: move
pnpacpi/pnpbios_init to after PCI init") moved the PnP RTC discovery
later, and now the ACPI RTC glue code doesn't find it any more, breaking
the RTC wakealarm sysfs interfaces, as reported by Rafael.
This really is fairly messy, and we have several annoying ordering
constraints here - the PnP code that sets up the RTC resources wants to
run after the PCI resources have to be registered, which in turn needs
to run after ACPI has at least enumerated the root PCI buses etc. Our
initcall ordering is not fine-grained enough to make this all painless.
So this moves the ACPI RTC glue ("acpi_rtc_init()") down to a regular
module call, which fixes the problem Rafael has. The reason this isn't
wonderful is that we really should do acpi_rtc_init before we do the
rtc_cmos init, and now those two are in the same module_init() section.
Which happens to work, but only because drivers/rtc is linked after
drivers/acpi. In other words, we still have a very subtle ordering
issue here. Grr.
Reported-and-tested-by: Rafael J. Wysocki <rjw@sisk.pl>
Acked-by: David Brownell <david-b@pacbell.net>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Fix a few instances of board code breakage introduced by the atmel-mci
platform interface changes.
Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
at32_select_periph() now takes an u32 bitmask rather than a single pin.
This allows to set multiple pins at once.
Signed-off-by: Alex Raimondi <mailinglist@miromico.ch>
Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>
deselecting one of the CPU type CONFIG_CPU_SUP_* config options
can render a kernel unbootable. Make sure this option is only
available if CONFIG_EMBEDDED is enabled.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
extend the help text of the CONFIG_CPU_SUP_* config options to
express what it does and what effects it has.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
We lock GlobalMid_Lock in header_assemble and then immediately unlock it
again without doing anything. Not sure what this was intended to do, but
remove it.
Signed-off-by: Jeff Layton <jlayton@redhat.com>
Signed-off-by: Steve French <sfrench@us.ibm.com>
propagate an error in enabling the PCI device.
Also eliminates this warning:
arch/x86/kernel/amd_iommu_init.c: In function ‘init_iommu_one’:
arch/x86/kernel/amd_iommu_init.c:726: warning: ignoring return value of ‘pci_enable_device’, declared with attribute warn_unused_result
Signed-off-by: Ingo Molnar <mingo@elte.hu>
fix:
arch/x86/kernel/io_apic_64.c: In function ‘print_local_APIC’:
arch/x86/kernel/io_apic_64.c:1284: warning: format ‘%08x’ expects type ‘unsigned int’, but argument 2 has type ‘long unsigned int’
arch/x86/kernel/io_apic_64.c:1285: warning: format ‘%08x’ expects type ‘unsigned int’, but argument 2 has type ‘long unsigned int’
We want to print the two halves of 'icr' at 32 bit width.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
fix warning:
arch/x86/kernel/early_printk.c:993: warning: ‘enable_debug_console’ defined but not used
Eliminate dead code.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
fix warning:
arch/x86/kernel/xsave.c: In function ‘save_i387_xstate’:
arch/x86/kernel/xsave.c:98: warning: ignoring return value of ‘__clear_user’, declared with attribute warn_unused_result
check the return value and act on it. We should not be ignoring faults
at this point.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Move the prototypes from the generic kernel.h header to the more
appropriate include/asm-x86/bios_ebda.h header file.
Also, remove the check from the power management code - this is a
pure x86 matter for now.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Done to prevent this failure of an Octopus merge:
Added arch/arm/include/asm/byteorder.h in both, but differently.
ERROR: Merge conflict in arch/arm/include/asm/byteorder.h
Auto-merging include/asm-x86/spinlock.h
ERROR: Merge conflict in include/asm-x86/spinlock.h
fatal: merge program failed
This adds a user_regset type for the x86 io permissions bitmap.
This makes it appear in core dumps (when ioperm has been used).
It will also make it visible to debuggers in the future.
Signed-off-by: Roland McGrath <roland@redhat.com>
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
[conflict resolutions: Signed-off-by: Ingo Molnar <mingo@elte.hu> ]
Do not crash when enumerating supported CPU architectures
SECURITY_INIT somehow ended up in x86_cpu_dev.init section. That caused printk
in code which prints supported architectures to hit #GP due to non-canonical
address being used.
Signed-off-by: Petr Vandrovec <petr@vandrovec.name>
Cc: thomas.petazzoni@free-electrons.com
Signed-off-by: Ingo Molnar <mingo@elte.hu>
The x86 implementation of early_ioremap has an off by one error. If we get
an object which ends on the first byte of a page we undermap by one page and
this causes a crash on boot with the ASUS P5QL whose DMI table happens to fit
this alignment.
The size computation is currently
last_addr = phys_addr + size - 1;
npages = (PAGE_ALIGN(last_addr) - phys_addr)
(Consider a request for 1 byte at alignment 0...)
Closes#11693
Debugging work by Ian Campbell/Felix Geyer
Signed-off-by: Alan Cox <alan@rehat.com>
Cc: <stable@kernel.org>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
It's possible for get_wchan() to dereference past task->stack + THREAD_SIZE
while iterating through instruction pointers if fp equals the upper boundary,
causing a kernel panic.
Signed-off-by: David Rientjes <rientjes@google.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Hard-coded timeout values of 250ms for writes and 100ms for reads are
currently used for MMC transactions over SPI. The spec states that the
timeout values from the card should be used.
Signed-off-by: Matthew Fleming <matthew.fleming@imgtec.com>
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
The MMC spec states that the timeout for accessing the CSD and CID
registers is 64 clock cycles.
Signed-off-by: Matthew Fleming <matthew.fleming@imgtec.com>
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
The variable 'scratch' is always initialized before it's used. The
conditional which is responsible for initialization of 'scratch' will
always evaluate 'true' when the first loop iteration occurs, and thus,
it's properly initialized. GCC doesn't see this, of course, so using
the uninitialized_var() macro seems to work for silencing this case.
Signed-off-by: Steven Noonan <steven@uplinklabs.net>
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
In include/linux/mmc/host.h, it is mentionned that the callback to
know if a card is present or not is get_ro(). But it's get_cd().
Signed-off-by: Thomas Petazzoni <thomas.petazzoni@free-electrons.com>
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
We use 512 byte blocks on all cards, and newer cards support nothing
else, so hard code it and make the code less complex.
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
Some high speed capable controllers forget to set the high speed
capability bit. Make sure we enable the functionality anyway.
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
The MMC block driver services requests one at a time and in strict
order. Indicate this to the block layer so that it can handle barriers
in an efficient manner.
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
Make sure we consider the maximum block count when we tell the block
layer about the maximum sector count. That way we don't have to chop
up the request ourselves.
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
Make sure we can be woken from the forced sleep that is done on errors.
Removing a card often results in -ENOMEDIUM or -EILSEQ so we previously
locked up the removal process for a second.
We could completely exit on -ENOMEDIUM, but it might be a transient
glitch so treat it like any other error.
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
The card detection delay was added early when the behaviour of the
card interrupt was still very much unknown (i.e. before there was a
public specification). As it is now known that it is a debounced signal,
reduce the delay to something more sensible.
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
The sdhci controllers can interrupt us when the busy state from the
card has ended, saving CPU cycles and power.
Signed-off-by: Pierre Ossman <drzeus@drzeus.cx>
If an external PHY is found the driver falls through to the default
case in the switch and overwrites the PHY ID. Add the missing break.
Signed-off-by: Guennadi Liakhovetski <lg@denx.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
* 'for_linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tytso/ext4: (43 commits)
ext4: Rename ext4dev to ext4
ext4: Avoid double dirtying of super block in ext4_put_super()
Update ext4 MAINTAINERS file
Hook ext4 to the vfs fiemap interface.
generic block based fiemap implementation
ocfs2: fiemap support
vfs: vfs-level fiemap interface
ext4: fix xattr deadlock
jbd2: Fix buffer head leak when writing the commit block
ext4: Add debugging markers that can be used by systemtap
jbd2: abort instead of waiting for nonexistent transaction
ext4: fix initialization of UNINIT bitmap blocks
ext4: Remove old legacy block allocator
ext4: Use readahead when reading an inode from the inode table
ext4: Improve the documentation for ext4's /proc tunables
ext4: Combine proc file handling into a single set of functions
ext4: move /proc setup and teardown out of mballoc.c
ext4: Don't use 'struct dentry' for internal lookups
ext4/jbd2: Avoid WARN() messages when failing to write to the superblock
ext4: use percpu data structures for lg_prealloc_list
...