Move the NX setup into a separate file so that it can be compiled
without stack-protection while leaving the rest of the mm/init code
protected.
Signed-off-by: Jeremy Fitzhardinge <jeremy.fitzhardinge@citrix.com>
x86-64 assumes NX is available by default, so we need to
explicitly check for it before using NX. Some first-generation
Intel x86-64 processors didn't support NX, and even recent systems
allow it to be disabled in BIOS.
[ Impact: prevent Xen crash on NX-less 64-bit machines ]
Signed-off-by: Jeremy Fitzhardinge <jeremy.fitzhardinge@citrix.com>
Cc: Stable Kernel <stable@kernel.org>
Split __phys_addr out into its own file so we can disable
-fstack-protector in a fine-grained fashion. Also it doesn't
have terribly much to do with the rest of ioremap.c.
Signed-off-by: Jeremy Fitzhardinge <jeremy.fitzhardinge@citrix.com>
-fstack-protector uses a special per-cpu "stack canary" value.
gcc generates special code in each function to test the canary to make
sure that the function's stack hasn't been overrun.
On x86-64, this is simply an offset of %gs, which is the usual per-cpu
base segment register, so setting it up simply requires loading %gs's
base as normal.
On i386, the stack protector segment is %gs (rather than the usual kernel
percpu %fs segment register). This requires setting up the full kernel
GDT and then loading %gs accordingly. We also need to make sure %gs is
initialized when bringing up secondary cpus too.
To keep things consistent, we do the full GDT/segment register setup on
both architectures.
Because we need to avoid -fstack-protected code before setting up the GDT
and because there's no way to disable it on a per-function basis, several
files need to have stack-protector inhibited.
[ Impact: allow Xen booting with stack-protector enabled ]
Signed-off-by: Jeremy Fitzhardinge <jeremy.fitzhardinge@citrix.com>
General description: kmemcheck is a patch to the linux kernel that
detects use of uninitialized memory. It does this by trapping every
read and write to memory that was allocated dynamically (e.g. using
kmalloc()). If a memory address is read that has not previously been
written to, a message is printed to the kernel log.
Thanks to Andi Kleen for the set_memory_4k() solution.
Andrew Morton suggested documenting the shadow member of struct page.
Signed-off-by: Vegard Nossum <vegardno@ifi.uio.no>
Signed-off-by: Pekka Enberg <penberg@cs.helsinki.fi>
[export kmemcheck_mark_initialized]
[build fix for setup_max_cpus]
Signed-off-by: Ingo Molnar <mingo@elte.hu>
[rebased for mainline inclusion]
Signed-off-by: Vegard Nossum <vegardno@ifi.uio.no>
Impact: cleanup
We take the 64-bit code and use it on 32-bit as well. The new file
is called mm/numa.c.
In a minor cleanup, we use cpu_none_mask instead of declaring a local
cpu_mask_none.
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Impact: unification
This patch introduces a common arch/x86/mm/init.c and moves the identical
free_init_pages() and free_initmem() functions to the file.
Signed-off-by: Pekka Enberg <penberg@cs.helsinki.fi>
LKML-Reference: <1236078906.2675.18.camel@penberg-laptop>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
The x86/Voyager subarch used to have this distinction between
'x86 SMP support' and 'Voyager SMP support':
config X86_SMP
bool
depends on SMP && ((X86_32 && !X86_VOYAGER) || X86_64)
This is a pointless distinction - Voyager can (and already does) use
smp_ops to implement various SMP quirks it has - and it can be extended
more to cover all the specialities of Voyager.
So remove this complication in the Kconfig space.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Impact: cleanup
Now that it's unified, move the (SMP) TLB flushing code from arch/x86/kernel/
to arch/x86/mm/, where it belongs logically.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Impact: introduce new APIs, separate kmap code from CONFIG_HIGHMEM
This takes the code used for CONFIG_HIGHMEM memory mappings except that
it's designed for dynamic IO resource mapping.
These fixmaps are available even with CONFIG_HIGHMEM turned off.
Signed-off-by: Keith Packard <keithp@keithp.com>
Signed-off-by: Eric Anholt <eric@anholt.net>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Impact: cleanup
We can remove MMIOTRACE_HOOKS and replace it with just MMIOTRACE.
MMIOTRACE_HOOKS is a remnant from the time when I thought that
something else could also use the kmmio facilities.
Signed-off-by: Pekka Paalanen <pq@iki.fi>
Acked-by: Steven Rostedt <rostedt@goodmis.org>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Out of line get_user_pages_fast fallback implementation, make it a weak
symbol, get rid of CONFIG_HAVE_GET_USER_PAGES_FAST.
Export the symbol to modules so lguest can use it.
Signed-off-by: Nick Piggin <npiggin@suse.de>
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Implement get_user_pages_fast without locking in the fastpath on x86.
Do an optimistic lockless pagetable walk, without taking mmap_sem or any
page table locks or even mmap_sem. Page table existence is guaranteed by
turning interrupts off (combined with the fact that we're always looking
up the current mm, means we can do the lockless page table walk within the
constraints of the TLB shootdown design). Basically we can do this
lockless pagetable walk in a similar manner to the way the CPU's pagetable
walker does not have to take any locks to find present ptes.
This patch (combined with the subsequent ones to convert direct IO to use
it) was found to give about 10% performance improvement on a 2 socket 8
core Intel Xeon system running an OLTP workload on DB2 v9.5
"To test the effects of the patch, an OLTP workload was run on an IBM
x3850 M2 server with 2 processors (quad-core Intel Xeon processors at
2.93 GHz) using IBM DB2 v9.5 running Linux 2.6.24rc7 kernel. Comparing
runs with and without the patch resulted in an overall performance
benefit of ~9.8%. Correspondingly, oprofiles showed that samples from
__up_read and __down_read routines that is seen during thread contention
for system resources was reduced from 2.8% down to .05%. Monitoring the
/proc/vmstat output from the patched run showed that the counter for
fast_gup contained a very high number while the fast_gup_slow value was
zero."
(fast_gup is the old name for get_user_pages_fast, fast_gup_slow is a
counter we had for the number of times the slowpath was invoked).
The main reason for the improvement is that DB2 has multiple threads each
issuing direct-IO. Direct-IO uses get_user_pages, and thus the threads
contend the mmap_sem cacheline, and can also contend on page table locks.
I would anticipate larger performance gains on larger systems, however I
think DB2 uses an adaptive mix of threads and processes, so it could be
that thread contention remains pretty constant as machine size increases.
In which case, we stuck with "only" a 10% gain.
The downside of using get_user_pages_fast is that if there is not a pte
with the correct permissions for the access, we end up falling back to
get_user_pages and so the get_user_pages_fast is a bit of extra work.
However this should not be the common case in most performance critical
code.
[akpm@linux-foundation.org: coding-style fixes]
[akpm@linux-foundation.org: build fix]
[akpm@linux-foundation.org: Kconfig fix]
[akpm@linux-foundation.org: Makefile fix/cleanup]
[akpm@linux-foundation.org: warning fix]
Signed-off-by: Nick Piggin <npiggin@suse.de>
Cc: Dave Kleikamp <shaggy@austin.ibm.com>
Cc: Andy Whitcroft <apw@shadowen.org>
Cc: Ingo Molnar <mingo@elte.hu>
Cc: Thomas Gleixner <tglx@linutronix.de>
Cc: Andi Kleen <andi@firstfloor.org>
Cc: Dave Kleikamp <shaggy@austin.ibm.com>
Cc: Badari Pulavarty <pbadari@us.ibm.com>
Cc: Zach Brown <zach.brown@oracle.com>
Cc: Jens Axboe <jens.axboe@oracle.com>
Reviewed-by: Peter Zijlstra <a.p.zijlstra@chello.nl>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
it's separate functionality that deserves its own file.
This also prepares 32-bit memtest support.
Signed-off-by: Yinghai Lu <yhlu.kernel@gmail.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Add a common arch/x86/mm/pgtable.c file for common pagetable functions.
Signed-off-by: Jeremy Fitzhardinge <jeremy.fitzhardinge@citrix.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Sets up pat_init() infrastructure.
PAT MSR has following setting.
PAT
|PCD
||PWT
|||
000 WB _PAGE_CACHE_WB
001 WC _PAGE_CACHE_WC
010 UC- _PAGE_CACHE_UC_MINUS
011 UC _PAGE_CACHE_UC
We are effectively changing WT from boot time setting to WC.
UC_MINUS is used to provide backward compatibility to existing /dev/mem
users(X).
reserve_memtype and free_memtype are new interfaces for maintaining alias-free
mapping. It is currently implemented in a simple way with a linked list and
not optimized. reserve and free tracks the effective memory type, as a result
of PAT and MTRR setting rather than what is actually requested in PAT.
pat_init piggy backs on mtrr_init as the rules for setting both pat and mtrr
are same.
Signed-off-by: Venkatesh Pallipadi <venkatesh.pallipadi@intel.com>
Signed-off-by: Suresh Siddha <suresh.b.siddha@intel.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Clean up the page table dumper (fix boundary conditions, table driven
address ranges, some formatting changes since it is no longer using
the kernel log but a separate virtual file), and generalize to 32
bits.
[ mingo@elte.hu: x86: fix the pagetable dumper ]
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
This patch adds code to the kernel to have an (optional)
/proc/kernel_page_tables debug file that basically dumps the kernel
pagetables; this allows us kernel developers to verify that nothing fishy is
going on and that the various mappings are set up correctly. This was quite
useful in finding various change_page_attr() bugs, and is very likely to be
useful in the future as well.
Signed-off-by: Arjan van de Ven <arjan@linux.intel.com>
Cc: mingo@elte.hu
Cc: tglx@tglx.de
Cc: hpa@zytor.com
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Unify arch/x86/mm/Makefile between 32 and 64 bits.
All configuration variables that are protected by Kconfig constraints
have been put in the common part of the Makefile; however, the NUMA
files are totally different between 32 and 64 bits and are handled via
an ifdef.
Signed-off-by: H. Peter Anvin <hpa@zytor.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
