The upper bound for HTB time diff needs to be scaled to PSCHED
units rather than just assuming usecs. The field mbuffer is used
in TDIFF_SAFE(), as an upper bound.
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Acked-by: Jamal Hadi Salim <hadi@cyberus.ca>
Signed-off-by: David S. Miller <davem@davemloft.net>
A panic was reported when receiving 1522 size packets if using
the default MTU. we should set the initial rx buffer length to the
value that e1000changemtu sets so that we can receive any packet
that would not be dropped by LPE=0.
Signed-off-by: Jesse Brandeburg <jesse.brandeburg@intel.com>
Signed-off-by: Auke Kok <auke.jan.h.kok@intel.com>
After removing the hardware CRC stripping which causes problems with
SOL and related issues, we need to compensate for this changed size.
Signed-off-by: Jesse Brandeburg <jesse.brandeburg@intel.com>
Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com>
The original suggested fix for netpoll was found to be racy on SMP
kernels. While it is highly unlikely that this race would ever be seen
in the real world due to current netpoll usage models, we implemented
this updated fix to address concerns.
Signed-off-by: Mitch Williams <mitch.a.williams@intel.com>
Signed-off-by: Auke Kok <auke-jan.h.kok@intel.com>
when data arrives at IP through loopback (and possibly other devices).
So the field needs to be cleared before it confuses the route code.
This was seen when running netem over loopback, but there are probably
other device cases. Maybe this should go into stable?
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Seem like quite a few splipped through the cracks. Here's a patch to
update all references I could find:
Signed-off-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
When pskb_trim has to defer to ___pksb_trim to trim the frag_list part of
the packet, the frag_list is not updated to reflect the trimming. This
will usually work fine until you hit something that uses the packet length
or tail from the frag_list.
Examples include esp_output and ip_fragment.
Another problem caused by this is that you can end up with a linear packet
with a frag_list attached.
It is possible to get away with this if we audit everything to make sure
that they always consult skb->len before going down onto frag_list. In
fact we can do the samething for the paged part as well to avoid copying
the data area of the skb. For now though, let's do the conservative fix
and update frag_list.
Many thanks to Marco Berizzi for helping me to track down this bug.
This 4-year old bug took 3 months to track down. Marco was very patient
indeed :)
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
* 'upstream' of git://ftp.linux-mips.org/pub/scm/upstream-linus: (53 commits)
[MIPS] sparsemem: fix crash in show_mem
[MIPS] vr41xx: Update workpad setup function
[MIPS] vr41xx: Update e55 setup function
[MIPS] vr41xx: Removed old v2.4 VRC4173 driver
[MIPS] vr41xx: Move IRQ numbers to asm-mips/vr41xx/irq.h
[MIPS] MIPSsim: Build fix, rename sim_timer_setup -> plat_timer_setup.
[MIPS] Remove unused code.
[MIPS] IP22 Fix brown paper bag in RTC code.
[MIPS] Atlas, Malta, SEAD: Don't disable interrupts in mips_time_init().
[MIPS] Replace board_timer_setup function pointer by plat_timer_setup.
[MIPS] Nuke redeclarations of board_time_init.
[MIPS] Remove redeclarations of setup_irq().
[MIPS] Nuke redeclarations of board_timer_setup.
[MIPS] Print out TLB handler assembly for debugging.
[MIPS] SMTC: Reformat to Linux style.
[MIPS] MIPSsim: Delete redeclaration of ll_local_timer_interrupt.
[MIPS] IP27: Reformatting.
[MIPS] IP27: Invoke setup_irq for timer interrupt so proc stats will be shown.
[MIPS] IP27: irq_chip startup method returns unsigned int.
[MIPS] IP27: struct irq_desc member handler was renamed to chip.
...
* master.kernel.org:/home/rmk/linux-2.6-arm:
[ARM] arch/arm/kernel/bios32.c: no need to set isa_bridge
[ARM] 3729/3: EABI padding rules necessitate the packed attribute of floatx80
[ARM] 3725/1: sharpsl_pm: warn about wrong temperature
[ARM] 3723/1: collie charging
[ARM] 3728/1: Restore missing CPU Hotplug irq helper
[ARM] 3727/1: fix ucb initialization on collie
[ARM] Allow Versatile to be built for AB and PB
[ARM] 3726/1: update {ep93xx,ixp2000,ixp23xx,lpd270,onearm} defconfigs to 2.6.18-rc1
[ARM] 3721/1: Small cleanup for locomo.c
Chandra Seetharaman reported SLAB crashes caused by the slab.c lock
annotation patch. There is only one chunk of that patch that has a
material effect on the slab logic - this patch undoes that chunk.
This was confirmed to fix the slab problem by Chandra.
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Tested-by: Chandra Seetharaman <sekharan@us.ibm.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
With sparsemem, pfn should be checked by pfn_valid() before pfn_to_page().
Signed-off-by: Atsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
This patch fixes a typo in arch/mips/sgi-ip22/ip22-time.c, leading to the
incorrect year being set into the RTC chip.
Signed-off-by: Julien BLACHE <jb@jblache.org>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
Long ago in the dark ages this was used a MIPS a.out binary to be used
with Milo which is obsolete since years.
Signed-off-by: Yoichi Yuasa <yoichi_yuasa@tripeaks.co.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
With some memory model other than FLATMEM, the single node can
contains some holes so there might be many invalid pages. For
example, with two 256M memory and one 256M hole, some variables
(num_physpage, totalpages, nr_kernel_pages, nr_all_pages, etc.) will
indicate that there are 768MB on this system. This is not desired
because, for example, alloc_large_system_hash() allocates too many
entries.
Use free_area_init_node() with counted zholes_size[] instead of
free_area_init().
For num_physpages, use number of ram pages instead of max_low_pfn.
Signed-off-by: Atsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
1. MIPS should select SPARSEMEM_STATIC since allocating bootmem in
memory_present() will corrupt bootmap area.
2. pfn_valid() for SPARSEMEM is defined in linux/mmzone.h
Signed-off-by: Atsushi Nemoto <anemo@mba.ocn.ne.jp>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
this patch restores the behaviour of the old (assembly-written)
interrupt handler, the handler is left as soon as a single interrupt
cause is handled.
Signed-off-by: Thiemo Seufer <ths@networkno.de>
Signed-off-by: Ralf Baechle <ralf@linux-mips.org>
