This is an example about how to add eventfd support to the current KAIO code,
in order to enable KAIO to post readiness events to a pollable fd (hence
compatible with POSIX select/poll). The KAIO code simply signals the eventfd
fd when events are ready, and this triggers a POLLIN in the fd. This patch
uses a reserved for future use member of the struct iocb to pass an eventfd
file descriptor, that KAIO will use to post events every time a request
completes. At that point, an aio_getevents() will return the completed result
to a struct io_event. I made a quick test program to verify the patch, and it
runs fine here:
http://www.xmailserver.org/eventfd-aio-test.c
The test program uses poll(2), but it'd, of course, work with select and epoll
too.
This can allow to schedule both block I/O and other poll-able devices
requests, and wait for results using select/poll/epoll. In a typical
scenario, an application would submit KAIO request using aio_submit(), and
will also use epoll_ctl() on the whole other class of devices (that with the
addition of signals, timers and user events, now it's pretty much complete),
and then would:
epoll_wait(...);
for_each_event {
if (curr_event_is_kaiofd) {
aio_getevents();
dispatch_aio_events();
} else {
dispatch_epoll_event();
}
}
Signed-off-by: Davide Libenzi <davidel@xmailserver.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Stick an unlikely() around is_aio(): I assert that most IO is synchronous.
Cc: Suparna Bhattacharya <suparna@in.ibm.com>
Cc: Ingo Molnar <mingo@elte.hu>
Cc: Benjamin LaHaise <bcrl@kvack.org>
Cc: Zach Brown <zach.brown@oracle.com>
Cc: Ulrich Drepper <drepper@redhat.com>
Cc: Christoph Hellwig <hch@lst.de>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Implement block device specific .direct_IO method instead of going through
generic direct_io_worker for block device.
direct_io_worker() is fairly complex because it needs to handle O_DIRECT on
file system, where it needs to perform block allocation, hole detection,
extents file on write, and tons of other corner cases. The end result is
that it takes tons of CPU time to submit an I/O.
For block device, the block allocation is much simpler and a tight triple
loop can be written to iterate each iovec and each page within the iovec in
order to construct/prepare bio structure and then subsequently submit it to
the block layer. This significantly speeds up O_D on block device.
[akpm@osdl.org: small speedup]
Signed-off-by: Ken Chen <kenneth.w.chen@intel.com>
Cc: Christoph Hellwig <hch@lst.de>
Cc: Zach Brown <zach.brown@oracle.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Remove the ki_retried member from struct kiocb. I think the idea was
bounced around a while back, but Arnaldo pointed out another reason that we
should dig it up when he pointed out that the last cacheline of struct
kiocb only contains 4 bytes. By removing the debugging member, we save
more than the 8 byte on 64 bit machines.
Signed-off-by: Benjamin LaHaise <bcrl@kvack.org>
Acked-by: Ken Chen <kenneth.w.chen@intel.com>
Acked-by: Zach Brown <zach.brown@oracle.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Separate delayable work items from non-delayable work items be splitting them
into a separate structure (delayed_work), which incorporates a work_struct and
the timer_list removed from work_struct.
The work_struct struct is huge, and this limits it's usefulness. On a 64-bit
architecture it's nearly 100 bytes in size. This reduces that by half for the
non-delayable type of event.
Signed-Off-By: David Howells <dhowells@redhat.com>
This work is initially done by Zach Brown to add support for vectored aio.
These are the core changes for AIO to support
IOCB_CMD_PREADV/IOCB_CMD_PWRITEV.
[akpm@osdl.org: huge build fix]
Signed-off-by: Zach Brown <zach.brown@oracle.com>
Signed-off-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Badari Pulavarty <pbadari@us.ibm.com>
Acked-by: Benjamin LaHaise <bcrl@kvack.org>
Acked-by: James Morris <jmorris@namei.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
This patch vectorizes aio_read() and aio_write() methods to prepare for
collapsing all aio & vectored operations into one interface - which is
aio_read()/aio_write().
Signed-off-by: Badari Pulavarty <pbadari@us.ibm.com>
Signed-off-by: Christoph Hellwig <hch@lst.de>
Cc: Michael Holzheu <HOLZHEU@de.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
BUG_ON() does this unlikely check itself, as bugs in Linux are unlikely
anyway :)
Signed-off-by: Rolf Eike Beer <eike-kernel@sf-tec.de>
Acked-by: Zach Brown <zach.brown@oracle.com>
Acked-by: Benjamin LaHaise <benjamin.c.lahaise@intel.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Reorder members of the kiocb structure to make sync kiocb setup faster. By
setting the elements sequentially, the write combining buffers on the CPU
are able to combine the writes into a single burst, which results in fewer
cache cycles being consumed, freeing them up for other code. This results
in a 10-20KB/s[*] increase on the bw_unix part of LMbench on my test
system.
* The improvement varies based on what other patches are in the system,
as there are a number of bottlenecks, so this number is not absolutely
accurate.
Signed-off-by: Benjamin LaHaise <benjamin.c.lahaise@intel.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
put_ioctx's refcount debugging was doing an atomic_read after dropping its
reference when it wasn't the last ref, leaving a tiny race for another freeing
thread to sneak into. This shifts the debugging before the ops, uses BUG_ON,
and reformats the defines a little. Sadly, moving to inlines increased the
code size but this change decreases the code size by a whole 9 bytes :)
Signed-off-by: Zach Brown <zach.brown@oracle.com>
Cc: Benjamin LaHaise <bcrl@kvack.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Sync iocbs have a life cycle that don't need a kioctx. Their retrying, if
any, is done in the context of their owner who has allocated them on the
stack.
The sole user of a sync iocb's ctx reference was aio_complete() checking for
an elevated iocb ref count that could never happen. No path which grabs an
iocb ref has access to sync iocbs.
If we were to implement sync iocb cancelation it would be done by the owner of
the iocb using its on-stack reference.
Removing this chunk from aio_complete allows us to remove the entire kioctx
instance from mm_struct, reducing its size by a third. On a i386 testing box
the slab size went from 768 to 504 bytes and from 5 to 8 per page.
Signed-off-by: Zach Brown <zach.brown@oracle.com>
Acked-by: Benjamin LaHaise <bcrl@kvack.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
AIO was adding a new context's max requests to the global total before
testing if that resulting total was over the global limit. This let
innocent tasks get their new limit tested along with a racing guilty task
that was crossing the limit. This serializes the _nr accounting with a
spinlock It also switches to using unsigned long for the global totals.
Individual contexts are still limited to an unsigned int's worth of
requests by the syscall interface.
The problem and fix were verified with a simple program that spun creating
and destroying a context while holding on to another long lived context.
Before the patch a task creating a tiny context could get a spurious EAGAIN
if it raced with a task creating a very large context that overran the
limit.
Signed-off-by: Zach Brown <zach.brown@oracle.com>
Cc: Benjamin LaHaise <bcrl@kvack.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
lock_kiocb() was introduced to serialize retrying and cancellation. In the
process of doing so it tried to sleep waiting for KIF_LOCKED while holding
the ctx_lock spinlock. Recent fixes have ensured that multiple concurrent
retries won't be attempted for a given iocb. Cancel has other problems and
has no significant in-tree users that have been complaining about it. So
for the immediate future we'll revert sleeping with the lock held and will
address proper cancellation and retry serialization in the future.
Signed-off-by: Zach Brown <zach.brown@oracle.com>
Acked-by: Benjamin LaHaise <bcrl@kvack.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Only one of the run or kick path is supposed to put an iocb on the run
list. If both of them do it than one of them can end up referencing a
freed iocb. The kick path could delete the task_list item from the wait
queue before getting the ctx_lock and putting the iocb on the run list.
The run path was testing the task_list item outside the lock so that it
could catch ki_retry methods that return -EIOCBRETRY *without* putting the
iocb on a wait queue and promising to call kick_iocb. This unlocked check
could then race with the kick path to cause both to try and put the iocb on
the run list.
The patch stops the run path from testing task_list by requring that any
ki_retry that returns -EIOCBRETRY *must* guarantee that kick_iocb() will be
called in the future. aio_p{read,write}, the only in-tree -EIOCBRETRY
users, are updated.
Signed-off-by: Zach Brown <zach.brown@oracle.com>
Signed-off-by: Benjamin LaHaise <bcrl@linux.intel.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
