Add basic netlink support to the Ethernet bridge. Including:
* dump interfaces in bridges
* monitor link status changes
* change state of bridge port
For some demo programs see:
http://developer.osdl.org/shemminger/prototypes/brnl.tar.gz
These are to allow building a daemon that does alternative
implementations of Spanning Tree Protocol.
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Speed of a interface may not be available until carrier
is detected in the case of autonegotiation. To get the correct value
we need to recheck speed after carrier event. But the check needs to
be done in a context that is similar to normal ethtool interface (can sleep).
Also, delay check for 1ms to try avoid any carrier bounce transitions.
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Make features of the bridge pseudo-device be a subset of the underlying
devices. Motivated by Xen and others who use bridging to do failover.
Signed-off-by: Catalin BOIE <catab at umrella.ro>
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
