drivers/acpi/namespace/nsparse.c:126: warning: int format, different type arg (arg 7)
drivers/acpi/tables/tbfadt.c:224: warning: unsigned int format, different type arg (arg 6)
drivers/acpi/utilities/utdebug.c:184: warning: cast from pointer to integer of different size
drivers/acpi/utilities/utdebug.c:184: warning: cast from pointer to integer of different size
drivers/acpi/utilities/utdebug.c:197: warning: cast from pointer to integer of different size
drivers/acpi/processor_idle.c:1093: warning: long long unsigned int format, u64 arg (arg 5)
Signed-off-by: Len Brown <len.brown@intel.com>
Added 2007 copyright to all module headers and signons. This affects
virtually every file in the ACPICA core subsystem, iASL compiler,
and the utilities.
Signed-off-by: Alexey Starikovskiy <alexey.y.starikovskiy@intel.com>
Signed-off-by: Len Brown <len.brown@intel.com>
The Table Manager component has been completely
redesigned and reimplemented. The new design is much
simpler, and reduces the overall code and data size of
the kernel-resident ACPICA by approximately 5%. Also,
it is now possible to obtain the ACPI tables very early
during kernel initialization, even before dynamic memory
management is initialized.
Signed-off-by: Alexey Starikovskiy <alexey.y.starikovskiy@intel.com>
Signed-off-by: Len Brown <len.brown@intel.com>
Removed a device initialization optimization introduced in
20051216 where the _STA method was not run unless an _INI
was also present for the same device. This optimization
could cause problems because it could allow _INI methods
to be run within a not-present device subtree (If a
not-present device had no _INI, _STA would not be run,
the not-present status would not be discovered, and the
children of the device would be incorrectly traversed.)
Implemented a new _STA optimization where namespace
subtrees that do not contain _INI are identified and
ignored during device initialization. Selectively running
_STA can significantly improve boot time on large machines
(with assistance from Len Brown.)
Implemented support for the device initialization case
where the returned _STA flags indicate a device not-present
but functioning. In this case, _INI is not run, but the
device children are examined for presence, as per the
ACPI specification.
Implemented an additional change to the IndexField support
in order to conform to MS behavior. The value written to
the Index Register is not simply a byte offset, it is a
byte offset in units of the access width of the parent
Index Field. (Fiodor Suietov)
Defined and deployed a new OSL interface,
acpi_os_validate_address(). This interface is called during
the creation of all AML operation regions, and allows
the host OS to exert control over what addresses it will
allow the AML code to access. Operation Regions whose
addresses are disallowed will cause a runtime exception
when they are actually accessed (will not affect or abort
table loading.)
Defined and deployed a new OSL interface,
acpi_os_validate_interface(). This interface allows the host OS
to match the various "optional" interface/behavior strings
for the _OSI predefined control method as appropriate
(with assistance from Bjorn Helgaas.)
Restructured and corrected various problems in the
exception handling code paths within DsCallControlMethod
and DsTerminateControlMethod in dsmethod (with assistance
from Takayoshi Kochi.)
Modified the Linux source converter to ignore quoted string
literals while converting identifiers from mixed to lower
case. This will correct problems with the disassembler
and other areas where such strings must not be modified.
The ACPI_FUNCTION_* macros no longer require quotes around
the function name. This allows the Linux source converter
to convert the names, now that the converter ignores
quoted strings.
Signed-off-by: Bob Moore <robert.moore@intel.com>
Signed-off-by: Len Brown <len.brown@intel.com>
Tagged all external interfaces to the subsystem with the
new ACPI_EXPORT_SYMBOL macro. This macro can be defined
as necessary to assist kernel integration. For Linux,
the macro resolves to the EXPORT_SYMBOL macro. The default
definition is NULL.
Added the ACPI_THREAD_ID type for the return value from
acpi_os_get_thread_id(). This allows the host to define this
as necessary to simplify kernel integration. The default
definition is ACPI_NATIVE_UINT.
Valery Podrezov fixed two interpreter problems related
to error processing, the deletion of objects, and placing
invalid pointers onto the internal operator result stack.
http://bugzilla.kernel.org/show_bug.cgi?id=6028http://bugzilla.kernel.org/show_bug.cgi?id=6151
Increased the reference count threshold where a warning is
emitted for large reference counts in order to eliminate
unnecessary warnings on systems with large namespaces
(especially 64-bit.) Increased the value from 0x400
to 0x800.
Due to universal disagreement as to the meaning of the
'c' in the calloc() function, the ACPI_MEM_CALLOCATE
macro has been renamed to ACPI_ALLOCATE_ZEROED so that the
purpose of the interface is 'clear'. ACPI_MEM_ALLOCATE and
ACPI_MEM_FREE are renamed to ACPI_ALLOCATE and ACPI_FREE.
Signed-off-by: Bob Moore <robert.moore@intel.com>
Signed-off-by: Len Brown <len.brown@intel.com>
Added 2006 copyright.
At SuSE's suggestion, enabled all error messages
without enabling function tracing, ie with CONFIG_ACPI_DEBUG=n
Replaced all instances of the ACPI_DEBUG_PRINT macro invoked at
the ACPI_DB_ERROR and ACPI_DB_WARN debug levels with
the ACPI_REPORT_ERROR and ACPI_REPORT_WARNING macros,
respectively. This preserves all error and warning messages
in the non-debug version of the ACPICA code (this has been
referred to as the "debug lite" option.) Over 200 cases
were converted to create a total of over 380 error/warning
messages across the ACPICA code. This increases the code
and data size of the default non-debug version by about 13K.
Added ACPI_NO_ERROR_MESSAGES flag to enable deleting all messages.
The size of the debug version remains about the same.
Signed-off-by: Bob Moore <robert.moore@intel.com>
Signed-off-by: Len Brown <len.brown@intel.com>
Implemented support to ignore an attempt to install/load
a particular ACPI table more than once. Apparently there
exists BIOS code that repeatedly attempts to load the same
SSDT upon certain events. Thanks to Venkatesh Pallipadi.
Restructured the main interface to the AML parser in
order to correctly handle all exceptional conditions. This
will prevent leakage of the OwnerId resource and should
eliminate the AE_OWNER_ID_LIMIT exceptions seen on some
machines. Thanks to Alexey Starikovskiy.
Support for "module level code" has been disabled in this
version due to a number of issues that have appeared
on various machines. The support can be enabled by
defining ACPI_ENABLE_MODULE_LEVEL_CODE during subsystem
compilation. When the issues are fully resolved, the code
will be enabled by default again.
Modified the internal functions for debug print support
to define the FunctionName parameter as a (const char *)
for compatibility with compiler built-in macros such as
__FUNCTION__, etc.
Linted the entire ACPICA source tree for both 32-bit
and 64-bit.
Signed-off-by: Robert Moore <robert.moore@intel.com>
Signed-off-by: Len Brown <len.brown@intel.com>
The use of the CPU stack in the debug version of the
subsystem has been considerably reduced. Previously, a
debug structure was declared in every function that used
the debug macros. This structure has been removed in
favor of declaring the individual elements as parameters
to the debug functions. This reduces the cumulative stack
use during nested execution of ACPI function calls at the
cost of a small increase in the code size of the debug
version of the subsystem. With assistance from Alexey
Starikovskiy and Len Brown.
Added the ACPI_GET_FUNCTION_NAME macro to enable the
compiler-dependent headers to define a macro that will
return the current function name at runtime (such as
__FUNCTION__ or _func_, etc.) The function name is used
by the debug trace output. If ACPI_GET_FUNCTION_NAME
is not defined in the compiler-dependent header, the
function name is saved on the CPU stack (one pointer per
function.) This mechanism is used because apparently there
exists no standard ANSI-C defined macro that that returns
the function name.
Alexey Starikovskiy redesigned and reimplemented the
"Owner ID" mechanism used to track namespace objects
created/deleted by ACPI tables and control method
execution. A bitmap is now used to allocate and free the
IDs, thus solving the wraparound problem present in the
previous implementation. The size of the namespace node
descriptor was reduced by 2 bytes as a result.
Removed the UINT32_BIT and UINT16_BIT types that were used
for the bitfield flag definitions within the headers for
the predefined ACPI tables. These have been replaced by
UINT8_BIT in order to increase the code portability of
the subsystem. If the use of UINT8 remains a problem,
we may be forced to eliminate bitfields entirely because
of a lack of portability.
Alexey Starikovksiy enhanced the performance of
acpi_ut_update_object_reference. This is a frequently used
function and this improvement increases the performance
of the entire subsystem.
Alexey Starikovskiy fixed several possible memory leaks
and the inverse - premature object deletion.
Signed-off-by: Len Brown <len.brown@intel.com>
Implemented support to execute Type 1 and Type 2 AML
opcodes appearing at the module level (not within a control
method.) These opcodes are executed exactly once at the
time the table is loaded. This type of code was legal up
until the release of ACPI 2.0B (2002) and is now supported
within ACPI CA in order to provide backwards compatibility
with earlier BIOS implementations. This eliminates the
"Encountered executable code at module level" warning that
was previously generated upon detection of such code.
Fixed a problem in the interpreter where an AE_NOT_FOUND
exception could inadvertently be generated during the
lookup of namespace objects in the second pass parse of
ACPI tables and control methods. It appears that this
problem could occur during the resolution of forward
references to namespace objects.
Added the ACPI_MUTEX_DEBUG #ifdef to the
acpi_ut_release_mutex function, corresponding to the same
the deadlock detection debug code to be compiled out in
the normal case, improving mutex performance (and overall
subsystem performance) considerably. As suggested by
Alexey Starikovskiy.
Implemented a handful of miscellaneous fixes for possible
memory leaks on error conditions and error handling
control paths. These fixes were suggested by FreeBSD and
the Coverity Prevent source code analysis tool.
Added a check for a null RSDT pointer in
acpi_get_firmware_table (tbxfroot.c) to prevent a fault
in this error case.
Signed-off-by Len Brown <len.brown@intel.com>
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
