After converting the cpu physical address to shub2 physical
addressing, the address was run through TO_PHYS() which
clobbered a high node offset bit causing the BTE to fail
on shub2 nodes with large memory. This fix corrects
that problem.
Signed-off-by: Russ Anderson (rja@sgi.com)
Signed-off-by: Tony Luck <tony.luck@intel.com>
SGI's prom has added a new feature which avoids an Altix-specific
MCA that can occur with excessive use of ia64_pal_cache_flush. This
patch adds the #define to the sn_feature_sets.h to reflect that bit
is taken.
Signed-off-by: Dean Roe <roe@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Migrate sn2 code to use mutex and completion events rather than
semaphores.
Signed-off-by: Jes Sorensen <jes@sgi.com>
Acked-by: Dean Nelson <dcn@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Add driver support for a 2 port PCI IOC3-based serial card on Altix boxes:
This is a re-submission. On the original submission I was asked to
organize the code so that the MIPS ioc3 ethernet and serial parts could be
used with this driver. Stanislaw Skowronek was kind enough to provide the
shim layer for this - thanks Stanislaw. This patch includes the shim layer
and the Altix PCI ioc3 serial driver. The MIPS merged ioc3 ethernet and
serial support is forthcoming.
Signed-off-by: Patrick Gefre <pfg@sgi.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
This patch separates the sn_flush_device_list struct into kernel and
common (both kernel and PROM accessible) structures. As it was, if the
size of a spinlock_t changed (due to additional CONFIG options, etc.) the
sal call which populated the sn_flush_device_list structs would erroneously
write data (and cause memory corruption and/or a panic).
This patch does the following:
1. Removes sn_flush_device_list and adds sn_flush_device_common and
sn_flush_device_kernel.
2. Adds a new SAL call to populate a sn_flush_device_common struct per
device, not per widget as previously done.
3. Correctly initializes each device's sn_flush_device_kernel spinlock_t
struct (before it was only doing each widget's first device).
Signed-off-by: Prarit Bhargava <prarit@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Altix (shub2) pushes the BTE clean-up into SAL.
This patch correctly interfaces with the now implemented SAL call.
It also fixes a bug when delaying clean-up to allow busy BTEs to
complete (or error out).
Signed-off-by: Russ Anderson <rja@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Cleanup a few items after moving xpc.h from arch/ia64/sn/kernel to
include/asm-ia64/sn.
Signed-off-by: Dean Nelson <dcn@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Move xpc.h from arch/ia64/sn/kernel to include/asm-ia64/sn without change.
Signed-off-by: Dean Nelson <dcn@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
This patch fixes a problem in XPC disengage processing whereby it was not
seeing the request to disengage from a remote partition, so the disengage
wasn't happening. The disengagement is suppose to transpire during the time
a XPC channel is disconnecting, and should be completed before the channel
is declared to be disconnected.
Signed-off-by: Dean Nelson <dcn@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Altix only patch to add fixup code that sets up
pci_controller->window. This code is a temporary
fix until ACPI support on Altix is added.
Also, corrects the usage of pci_dev->sysdata,
which had previously been used to reference
platform specific device info, to now point to
a pci_controller struct.
Signed-off-by: John Keller <jpk@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Add support for old versions of the SN PROMs. Eventually this
support will be deleted but it is useful right now to continue
supporting older PROMs.
Signed-off-by: Jack Steiner <steiner@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
This patch addresses a few issues with the open/close protocol that
were revealed by the newly added disengage functionality combined
with more extensive testing.
Signed-off-by: Dean Nelson <dcn@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Remove all references to the bist_lock in the SN code as it
is not used for anything.
Signed-off-by: Dean Roe <roe@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Increase the maximum system size of SGI SN systems. Note that
this is not the maximum SSI size. The maximum system size is
the number of nodes in the numalink domain.
Signed-off-by: Jack Steiner <steiner@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
This patch adds a #define for SN_SAL_IOIF_PCI_SAFE and makes that the
preferred method of implementing sn_pci_legacy_read() and
sn_pci_legacy_write().
This SAL call has been present in SGI proms since version 4.10. If the
SN_SAL_IOIF_PCI_SAFE call fails, revert to the previous code for compatability
with older proms.
Signed-off-by: Mark Maule <maule@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Some of the SN code & #defines related to compact nodes & IO discovery
have gotten stale over the years. This patch attempts to clean them up.
Some of the various SN MAX_xxx #defines were also unclear & misused.
The primary changes are:
- use MAX_NUMNODES. This is the generic linux #define for the number
of nodes that are known to the generic kernel. Arrays & loops
for constructs that are 1:1 with linux-defined nodes should
use the linux #define - not an SN equivalent.
- use MAX_COMPACT_NODES for MAX_NUMNODES + NUM_TIOS. This is the
number of nodes in the SSI system. Compact nodes are a hack to
get around the IA64 architectural limit of 256 nodes. Large SGI
systems have more than 256 nodes. When we upgrade to ACPI3.0,
I _hope_ that all nodes will be real nodes that are known to
the generic kernel. That will allow us to delete the notion
of "compact nodes".
- add MAX_NUMALINK_NODES for the total number of nodes that
are in the numalink domain - all partitions.
- simplified (understandable) scan_for_ionodes()
- small amount of cleanup related to cnodes
Signed-off-by: Jack Steiner <steiner@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Resend using accessors instead of volatile qualifiers per hch comments, and
easier to understand convenience macros per rja comments.
Patch to apply volatile semantics when accessing MMR's in various SN files.
Signed-off-by: Mark Maule <maule@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
When XPC is being shutdown (i.e., rmmod, reboot) it doesn't ensure that
other partitions with whom it was connected have completely disengaged
from any attempt at cross-partition memory references. This can lead to
MCAs in any of these other partitions when the partition is reset.
Signed-off-by: Dean Nelson <dcn@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
1) workaround a h/w reset issue
2) to improve the determination of FPGA-based h/w in
the arch/ia64/sn/kernel/tiocx code.
Signed-off-by: Bruce Losure <blosure@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
- notifying the PROM of specific features that are supported by the OS.
This is used to enable PROM feature if and only if the corresponding
feature is implemented in the OS
- fetch feature sets that are supported by the current PROM. This allows
the OS to selectively enable features when the PROM support is available.
Signed-off-by: Jack Steiner <steiner@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Some shub2 changes were not in the tree when Greg cleaned up the sn2
region definitions in 1b66776da7, so this
one didn't get fixed.
Signed-off-by: Tony Luck <tony.luck@intel.com>
Altix patch to abstract irq_affinity down to the pci provider level since
different SGI hardware implements this in different ways.
Signed-off-by: Mark Maule <maule@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Clean up of SGI SN partitioning related code.
The SN_SAL_GET_SN_INFO SAL call returns the partition ID, making
the SN_SAL_SYSCTL_PARTITION_GET SAL call redundant. Remove sn_partid
and use sn_partition_id.
Signed-off-by: Russ Anderson (rja@sgi.com)
Signed-off-by: Tony Luck <tony.luck@intel.com>
Add a new exported function for determining the nearest node
with CPUs for I/O nodes and fix a bug where the hwperf dynamic
misc device was being registered before misc_init().
Signed-off-by: Mark Goodwin <markgw@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Bugfix to export PCI topology information in /proc/sgi_sn/sn_topology.
Signed-off-by: Mark Goodwin <markgw@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Shub2 provides a much improved mechanism for issuing internode
TLB purges. Add code to support the newer mechanism. There is also
some debug code (disabled) that is useful for testing.
Collect statistics on the number, type & duration of TLB purges.
This data will be useful for making future improvements in the algorithms.
Signed-off-by: Jack Steiner <steiner@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Update the SN address macros so that they work on both shub1
and shub2. Most of the code to support shub2 was added last year
but this patch fixes a few bugs and adds macros to help generate
both processor-specific physical addresses & numalink physical
addresses. More cleanup & optimization will be done later.
Signed-off-by: Jack Steiner <steiner@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Altix patch to add an SN pci provider for TIOCE, which is SGI's
PCI Express implementation.
Signed-off-by: Mark Maule <maule@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Altix patch to add TIO "huge-window" address support to sn_dma_flush().
Update copyright in affected files.
Signed-off-by: Mark Maule <maule@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Altix patch to abstract the force_interrupt() mechanism away from the
pcibr provider.
Signed-off-by: Mark Maule <maule@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Cosmetic altix patch to rename SGI_PCIBR_ERROR to something more generic and
remove a duplicate #define.
Signed-off-by: Mark Maule <maule@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
The Altix subarch does not provide node information via ACPI. Instead hooks
are used to fixup pci structures. This patch determines the nodes for Altix
PCI busses.
Remote Bridges:
---------------
Altix supports remote I/O nodes without memory or processors but with bridges.
The TIOCA type of bridge is an AGP bridge and the PROM provides information
about the closest node. That information will be returned by pcibus_to_node.
The TIOCP remote bridge type is a PCI bridge but the PROM does not provide a
closest node id. pcibus_to_node will return -1 for devices on those bridges
meaning that device control structures may be allocated on any node.
Safeguard:
----------
Should the fixups result in invalid node information for a pci controller then
a warning will be printed and pcibus_to_node will return -1.
This patch also fixes the "FIXME" in sn_dma_alloc_coherent. This means that
dma_alloc_coherent will now use alloc_pages_node to allocate memory local to
the node that the PCI device is connected to.
Signed-off-by: Christoph Lameter <clameter@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
This patch removes the CONFIG_IA64_SGI_SN_SIM option entirely, allowing
any kernel bootable on sn2 to also be booted in the simulator.
Boot tested on Altix and HP rx2600.
Signed-off-by: Greg Edwards <edwardsg@sgi.com>
Signed-off-by: Tony Luck <tony.luck@intel.com>
changing CONFIG_LOCALVERSION rebuilds too much, for no appearent reason.
Signed-off-by: Olaf Hering <olh@suse.de>
Signed-off-by: Tony Luck <tony.luck@intel.com>
Jesse Barnes provided the original version of this patch months ago, but
other changes kept conflicting with it, so it got deferred. Greg Edwards
dug it out of obscurity just over a week ago, and almost immediately
another conflicting patch appeared (Bob Picco's memory-less nodes).
I've resolved the conflicts and got it running again. CONFIG_SGI_TIOCX
is set to "y" in defconfig, which causes a Tiger to not boot (oops in
tiocx_init). But that can be resolved later ... get this in now before it
gets stale again.
Signed-off-by: Tony Luck <tony.luck@intel.com>
