Make udp_encap_rcv use pskb_may_pull
IPsec with NAT-T breaks on some notebooks using the latest e1000 chipset,
when header split is enabled. When receiving sufficiently large packets, the
driver puts everything up to and including the UDP header into the header
portion of the skb, and the rest goes into the paged part. udp_encap_rcv
forgets to use pskb_may_pull, and fails to decapsulate it. Instead, it
passes it up it to the IKE daemon.
Signed-off-by: Olaf Kirch <okir@suse.de>
Signed-off-by: Jean Delvare <jdelvare@suse.de>
Signed-off-by: David S. Miller <davem@davemloft.net>
UDP tracks corking status through the pending variable. The
IP layer also tracks it through the socket write queue. It
is possible for the two to get out of sync when MSG_PROBE is
used.
This patch changes UDP to check the write queue to ensure
that the two stay in sync.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
->faddr is net-endian; annotated as such, variables inferred to be net-endian
annotated.
Signed-off-by: Al Viro <viro@zeniv.linux.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>
This also kills a warning while building ipv6:
net/ipv6/udp.c: In function ‘udp_v6_get_port’:
net/ipv6/udp.c:66: warning: passing argument 3 of ‘udp_get_port’ from incompatible pointer type
Signed-off-by: David S. Miller <davem@davemloft.net>
This patch creates one common function which is called by
udp_v4_get_port() and udp_v6_get_port(). As a result,
* duplicated code is removed
* udp_port_rover and local port lookup can now be removed from udp.h
* further savings follow since the same function will be used by UDP-Litev4
and UDP-Litev6
In contrast to the patch sent in response to Yoshifujis comments
(fixed by this variant), the code below also removes the
EXPORT_SYMBOL(udp_port_rover), since udp_port_rover can now remain
local to net/ipv4/udp.c.
Signed-off-by: Gerrit Renker <gerrit@erg.abdn.ac.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>
Replace CHECKSUM_HW by CHECKSUM_PARTIAL (for outgoing packets, whose
checksum still needs to be completed) and CHECKSUM_COMPLETE (for
incoming packets, device supplied full checksum).
Patch originally from Herbert Xu, updated by myself for 2.6.18-rc3.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
This labels the flows that could utilize IPSec xfrms at the points the
flows are defined so that IPSec policy and SAs at the right label can
be used.
The following protos are currently not handled, but they should
continue to be able to use single-labeled IPSec like they currently
do.
ipmr
ip_gre
ipip
igmp
sit
sctp
ip6_tunnel (IPv6 over IPv6 tunnel device)
decnet
Signed-off-by: Venkat Yekkirala <vyekkirala@TrustedCS.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
No code changes, just tidying up, in some cases moving EXPORT_SYMBOLs
to just after the function exported, etc.
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
This patch extends {get|set}sockopt compatibility layer in order to
move protocol specific parts to their place and avoid huge universal
net/compat.c file in the future.
Signed-off-by: Dmitry Mishin <dim@openvz.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
Keep the conntrack reference until policy checks have been performed for
IPsec NAT support. The reference needs to be dropped before a packet is
queued to avoid having the conntrack module unloadable.
Signed-off-by: Patrick McHardy <kaber@trash.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
To help in reducing the number of include dependencies, several files were
touched as they were getting needed headers indirectly for stuff they use.
Thanks also to Alan Menegotto for pointing out that net/dccp/proto.c had
linux/dccp.h include twice.
Signed-off-by: Arnaldo Carvalho de Melo <acme@mandriva.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Since udp_checksum_init always returns 0 there is no point in
having it return a value.
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
When a packet is obtained from skb_recv_datagram with MSG_PEEK enabled
it is left on the socket receive queue. This means that when we detect
a checksum error we have to be careful when trying to free the packet
as someone could have dequeued it in the time being.
Currently this delicate logic is duplicated three times between UDPv4,
UDPv6 and RAWv6. This patch moves them into a one place and simplifies
the code somewhat.
This is based on a suggestion by Eric Dumazet.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
Here is the patch that introduces the generic skb_checksum_complete
which also checks for hardware RX checksum faults. If that happens,
it'll call netdev_rx_csum_fault which currently prints out a stack
trace with the device name. In future it can turn off RX checksum.
I've converted every spot under net/ that does RX checksum checks to
use skb_checksum_complete or __skb_checksum_complete with the
exceptions of:
* Those places where checksums are done bit by bit. These will call
netdev_rx_csum_fault directly.
* The following have not been completely checked/converted:
ipmr
ip_vs
netfilter
dccp
This patch is based on patches and suggestions from Stephen Hemminger
and David S. Miller.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
A UDP packet may contain extra data that needs to be trimmed off.
But when doing so, UDP forgets to fixup the skb checksum if CHECKSUM_HW
is being used.
I think this explains the case of a NFS receive using skge driver
causing 'udp hw checksum failures' when interacting with a crufty
settop box.
Signed-off-by: Stephen Hemminger <shemminger@osdl.org>
Signed-off-by: David S. Miller <davem@davemloft.net>
This patch puts mostly read only data in the right section
(read_mostly), to help sharing of these data between CPUS without
memory ping pongs.
On one of my production machine, tcp_statistics was sitting in a
heavily modified cache line, so *every* SNMP update had to force a
reload.
Signed-off-by: Eric Dumazet <dada1@cosmosbay.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Lots of places just needs the states, not even linux/tcp.h, where this
enum was, needs it.
This speeds up development of the refactorings as less sources are
rebuilt when things get moved from net/tcp.h.
Signed-off-by: Arnaldo Carvalho de Melo <acme@ghostprotocols.net>
Signed-off-by: David S. Miller <davem@davemloft.net>
Here's a small patch to cleanup NETDEBUG() use in net/ipv4/ for Linux
kernel 2.6.13-rc5. Also weird use of indentation is changed in some
places.
Signed-off-by: Heikki Orsila <heikki.orsila@iki.fi>
Signed-off-by: David S. Miller <davem@davemloft.net>
Steven Hand <Steven.Hand@cl.cam.ac.uk> wrote:
>
> Reconstructed forward trace:
>
> net/ipv4/udp.c:1334 spin_lock_irq()
> net/ipv4/udp.c:1336 udp_checksum_complete()
> net/core/skbuff.c:1069 skb_shinfo(skb)->nr_frags > 1
> net/core/skbuff.c:1086 kunmap_skb_frag()
> net/core/skbuff.h:1087 local_bh_enable()
> kernel/softirq.c:0140 WARN_ON(irqs_disabled());
The receive queue lock is never taken in IRQs (and should never be) so
we can simply substitute bh for irq.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
Ross moved. Remove the bad email address so people will find the correct
one in ./CREDITS.
Signed-off-by: Jesper Juhl <juhl-lkml@dif.dk>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
The following patch just makes the header part of the skb writeable.
This is needed since we modify the IP headers just a few lines below.
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
Signed-off-by: David S. Miller <davem@davemloft.net>
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
