USBC gnd mic swap is taken care of by FSA4480.
Gpio does not need to be swapped for this purpose.
CRs-Fixed: 2323772
Change-Id: Ida490995761ec5361ff2302b990d3c6fe1f32f85
Signed-off-by: Vatsal Bucha <vbucha@codeaurora.org>
Add hostless FE and TDM BE DAI links for
TERT TDM TX7 and SEC TDM RX7 ports.
Change-Id: I57fed1162c5dc175475e7990f57d4a010a9057f2
Signed-off-by: Derek Chen <chenche@codeaurora.org>
Sometimes observed that session is taken more time to teardown
after ssr. Increase timeout to allow more time for session
to be tear down.
Change-Id: I3f1b4d8f583ad5b9c8f5e1b90af9c576ae6bd2b2
Signed-off-by: Ramprasad Katkam <katkam@codeaurora.org>
Add configuration flag to make use of 32channel support from
QDSP6.
Change-Id: I1e491b1ec870234140e914add4f177e5351b9953
Signed-off-by: Mangesh Kunchamwar <mangeshk@codeaurora.org>
Currently, the fs_cntr for MAD is enabled whenever the MAD
audio path is enabled. But, a new issue is reported where
MAD fs_cntr is required even for some of the non-MAD paths.
As per hardware requirements, enable the MAD fs_cntr always
from the codec default registers.
Change-Id: I6fe8f663b82e711b4194aa51a3e21150aa98cf02
Signed-off-by: Bhalchandra Gajare <gajare@codeaurora.org>
SXR1120 has additional gpio for micbias supply to be
enabled. Add control for this gpio and enable it.
Change-Id: Ica4ea9765db9bd48a1f8eb010d82d2687c8abbb9
Signed-off-by: Vatsal Bucha <vbucha@codeaurora.org>
When micbias is enabled set curr to higher value for
vreg bob bypass and when it is disabled set it
to default value for sm6150.
CRs-Fixed: 2315478
Change-Id: I451506002f382e666d47bc83944bdc8dbbedcad8
Signed-off-by: Vatsal Bucha <vbucha@codeaurora.org>
Pop is observed on HPH playback start. Enable SWR port
config setup before HPH PA enable.
Change-Id: I2253be1c7e4d8df2bffd7bd0396ceb72a5018637
Signed-off-by: Laxminath Kasam <lkasam@codeaurora.org>
Add widget and routing support for vdd-buck supply
as dynamic for all rx usecases.
Change-Id: I1e67e7e950e33a0d98900ee0b20e0dc818a7936d
Signed-off-by: Tanya Dixit <tdixit@codeaurora.org>
If interrupt indicates a fault in multichannel case,
reset all cluster devices in a specific order.
Change-Id: I077ff65c5f2b5e656fcdf6533fde04eba426e322
Signed-off-by: Romed Schur <rschur@codeaurora.org>
If headset is connected during SSR, after recovery mbhc
driver expects a new detection event as the driver is reinitialized.
Reset detection type to insertion to retrigger a hw interrupt
for mbhc driver.
Change-Id: I55705eb6b6a289deb5dc16a4b9ef6252082a3d9a
Signed-off-by: Ramprasad Katkam <katkam@codeaurora.org>
The format change event signaling for SPDIF input interfaces
is adapted to provide format information through sysfs nodes.
Change-Id: Ifab1074a0e4b13e08813e27f8694023c2c47bfe1
Signed-off-by: Ralf Herz <rherz@codeaurora.org>
Signed-off-by: Mangesh Kunchamwar <mangeshk@codeaurora.org>
Compressed streams now do support up to 32 channels.
Use new ADSP API for 32 channels if ADSP supports this.
If not fall back to 8 channel API.
Change-Id: Ief6fe189a6a34f15cfb96bfb9cb7d97b03633b95
Signed-off-by: Dieter Luecking <dieterl@codeaurora.org>
Signed-off-by: Mangesh Kunchamwar <mangeshk@codeaurora.org>
AFE MI2S interfaces now support up to 8 data lines
(16 channels). Add support for the same.
Make senary PCM and MI2S ports available.
Change-Id: I810dbe1c12ff091b3b4604d9e59f7015e3a55c98
Signed-off-by: Dieter Luecking <dieterl@codeaurora.org>
Signed-off-by: Mangesh Kunchamwar <mangeshk@codeaurora.org>
AFE MI2S interfaces now support up to 8 data lines
(16 channels). Add DAI support for the same.
Change-Id: I7c507c0161733094c1260731c7a046561fb63200
Signed-off-by: Dieter Luecking <dieterl@codeaurora.org>
Signed-off-by: Mangesh Kunchamwar <mangeshk@codeaurora.org>
PCM streams do now support up to 32 channels.
Extend Playback Channel Map mixer control to 32
channels. Use new DSP 32 channel API if DSP version
supports it. If not fall back to 8 channels API.
Change-Id: I74c4f91b0c9fab2a963690ba8143ebea36ad23dd
Signed-off-by: Dieter Luecking <dieterl@codeaurora.org>
Signed-off-by: Mangesh Kunchamwar <mangeshk@codeaurora.org>
The format change event signaling for EP92 HDMI input is adapted
to provide format information through sysfs nodes.
Chip configuration is done through sysfs as well.
Change-Id: I8c930ca5647899b4434272009699763c32fe9d04
Signed-off-by: Ralf Herz <rherz@codeaurora.org>
Signed-off-by: Mangesh Kunchamwar <mangeshk@codeaurora.org>
Add metadata to configure latency mode for DSP transcode
loopback to set legacy or low latency path. Userspace API
introduced to configure the same.
Change-Id: I914c68a9e9d8647530b72c42548e571b7508c423
Signed-off-by: Siddartha Shaik <sshaik@codeaurora.org>
Signed-off-by: Surendar Karka <skarka@codeaurora.org>