remap() the region we get from mmap() to mark the fact that we are
using all of the available slack space. Any slack space is used
to form a simple brk region, and potentially more stack space than
requested at load time.
Any searches of the vma chain may well fail looking for
stack (and especially arg) addresses if the remaping is not done.
The simplest example is /proc/<pid>/cmdline, since the args
are pretty much always at the top of the data/bss/stack region.
Signed-off-by: Greg Ungerer <gerg@uclinux.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
This patch changes struct file to use struct path instead of having
independent pointers to struct dentry and struct vfsmount, and converts all
users of f_{dentry,vfsmnt} in fs/ to use f_path.{dentry,mnt}.
Additionally, it adds two #define's to make the transition easier for users of
the f_dentry and f_vfsmnt.
Signed-off-by: Josef "Jeff" Sipek <jsipek@cs.sunysb.edu>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
binfmt_flat.c calls set_personality with PER_LINUX as the personality.
On the arm architecture this results in the program running in 26bit
usermode. PER_LINUX_32BIT should be used instead. This doesn't affect
other architectures that use binfmt_flat.
Signed-off-by: Greg Ungerer <gerg@uclinux.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Bernd Schmidt points out that binfmt_flat is now leaving the exec file open
while the application runs. This offsets all the application's fd numbers.
We should have closed the file within exec(), not at exit()-time.
But there doesn't seem to be a lot of point in doing all this just to avoid
going over RLIMIT_NOFILE by one fd for a few microseconds. So take the EMFILE
checking out again. This will cause binfmt_flat to again fail LTP's
exec-should-return-EMFILE-when-fdtable-is-full test. That test appears to be
wrong anyway - Open Group specs say nothing about exec() returning EMFILE.
Cc: Bernd Schmidt <bernd.schmidt@analog.com>
Cc: Greg Ungerer <gerg@uclinux.org>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
In binfmt_flat.c, the flat binary loader should check file descriptor table
and install the fd on the file.
Convert the function to single-exit and fix this bug.
Signed-off-by: "Luke Yang" <luke.adi@gmail.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Modify the initial trace output (which is based on flags in the binary
header) so that it is not done until after the magic number check. This
may well not be a flat format binary, so the flags could be invalid.
(Prime example, running a script).
Changes prompted by patches from Stuart Hughs.
Signed-off-by: Greg Ungerer <gerg@uclinux.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
)
From: Adrian Bunk <bunk@stusta.de>
- create one common dump_thread() prototype in kernel.h
- dump_thread() is only used in fs/binfmt_aout.c and can therefore be
removed on all architectures where CONFIG_BINFMT_AOUT is not
available
Signed-off-by: Adrian Bunk <bunk@stusta.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
How is anon_rss initialized? In dup_mmap, and by mm_alloc's memset; but
that's not so good if an mm_counter_t is a special type. And how is rss
initialized? By set_mm_counter, all over the place. Come on, we just need to
initialize them both at once by set_mm_counter in mm_init (which follows the
memcpy when forking).
Signed-off-by: Hugh Dickins <hugh@veritas.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Use MAP_PRIVATE when calling mmap to get memory for the code region.
The flat loader was using MAP_SHARED, but underlying changes to the
MMUless mmap means this is now wrong.
Signed-off-by: Greg Ungerer <gerg@uclinux.com>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Make sure that binfmt_flat passes the correct flags into do_mmap(). nommu's
validate_mmap_request() will simple return -EINVAL if we try and pass it a
flags value of zero.
Signed-off-by: Yoshinori Sato <ysato@users.sourceforge.jp>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
