# # Makefile for the Linux kernel device drivers. # # 15 Sep 2000, Christoph Hellwig <hch@infradead.org> # Rewritten to use lists instead of if-statements. # obj-$(CONFIG_PCI) += pci/ obj-$(CONFIG_PARISC) += parisc/ obj-y += video/ obj-$(CONFIG_ACPI) += acpi/ # PnP must come after ACPI since it will eventually need to check if acpi # was used and do nothing if so obj-$(CONFIG_PNP) += pnp/ # char/ comes before serial/ etc so that the VT console is the boot-time # default. obj-y += char/ obj-$(CONFIG_CONNECTOR) += connector/ # i810fb and intelfb depend on char/agp/ obj-$(CONFIG_FB_I810) += video/i810/ obj-$(CONFIG_FB_INTEL) += video/intelfb/ # we also need input/serio early so serio bus is initialized by the time # serial drivers start registering their serio ports obj-$(CONFIG_SERIO) += input/serio/ obj-y += serial/ obj-$(CONFIG_PARPORT) += parport/ obj-y += base/ block/ misc/ mfd/ net/ media/ obj-$(CONFIG_NUBUS) += nubus/ obj-$(CONFIG_ATM) += atm/ obj-$(CONFIG_PPC_PMAC) += macintosh/ obj-$(CONFIG_IDE) += ide/ obj-$(CONFIG_FC4) += fc4/ obj-$(CONFIG_SCSI) += scsi/ obj-$(CONFIG_FUSION) += message/ obj-$(CONFIG_IEEE1394) += ieee1394/ obj-y += cdrom/ obj-$(CONFIG_MTD) += mtd/ obj-$(CONFIG_PCCARD) += pcmcia/ obj-$(CONFIG_DIO) += dio/ obj-$(CONFIG_SBUS) += sbus/ obj-$(CONFIG_ZORRO) += zorro/ obj-$(CONFIG_MAC) += macintosh/ obj-$(CONFIG_ATA_OVER_ETH) += block/aoe/ obj-$(CONFIG_PARIDE) += block/paride/ obj-$(CONFIG_TC) += tc/ obj-$(CONFIG_USB) += usb/ obj-$(CONFIG_USB_GADGET) += usb/gadget/ obj-$(CONFIG_GAMEPORT) += input/gameport/ obj-$(CONFIG_INPUT) += input/ obj-$(CONFIG_I2O) += message/ obj-$(CONFIG_I2C) += i2c/ obj-$(CONFIG_W1) += w1/ obj-$(CONFIG_HWMON) += hwmon/ obj-$(CONFIG_PHONE) += telephony/ obj-$(CONFIG_MD) += md/ obj-$(CONFIG_BT) += bluetooth/ obj-$(CONFIG_ISDN) += isdn/ obj-$(CONFIG_MCA) += mca/ obj-$(CONFIG_EISA) += eisa/ obj-$(CONFIG_CPU_FREQ) += cpufreq/ obj-$(CONFIG_MMC) += mmc/ obj-$(CONFIG_INFINIBAND) += infiniband/ obj-$(CONFIG_SGI_IOC4) += sn/ obj-y += firmware/ obj-$(CONFIG_CRYPTO) += crypto/