android_kernel_xiaomi_sm8350/drivers/pinctrl/tegra/pinctrl-tegra.h
Sowjanya Komatineni 9870acd374 pinctrl: tegra: Add suspend and resume support
This patch adds support for Tegra pinctrl driver suspend and resume.

During suspend, context of all pinctrl registers are stored and
on resume they are all restored to have all the pinmux and pad
configuration for normal operation.

Acked-by: Thierry Reding <treding@nvidia.com>
Reviewed-by: Dmitry Osipenko <digetx@gmail.com>
Signed-off-by: Sowjanya Komatineni <skomatineni@nvidia.com>
Link: https://lore.kernel.org/r/1564607463-28802-2-git-send-email-skomatineni@nvidia.com
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
2019-08-05 11:19:35 +02:00

202 lines
6.0 KiB
C

/* SPDX-License-Identifier: GPL-2.0-only */
/*
* Driver for the NVIDIA Tegra pinmux
*
* Copyright (c) 2011, NVIDIA CORPORATION. All rights reserved.
*/
#ifndef __PINMUX_TEGRA_H__
#define __PINMUX_TEGRA_H__
struct tegra_pmx {
struct device *dev;
struct pinctrl_dev *pctl;
const struct tegra_pinctrl_soc_data *soc;
const char **group_pins;
int nbanks;
void __iomem **regs;
u32 *backup_regs;
};
enum tegra_pinconf_param {
/* argument: tegra_pinconf_pull */
TEGRA_PINCONF_PARAM_PULL,
/* argument: tegra_pinconf_tristate */
TEGRA_PINCONF_PARAM_TRISTATE,
/* argument: Boolean */
TEGRA_PINCONF_PARAM_ENABLE_INPUT,
/* argument: Boolean */
TEGRA_PINCONF_PARAM_OPEN_DRAIN,
/* argument: Boolean */
TEGRA_PINCONF_PARAM_LOCK,
/* argument: Boolean */
TEGRA_PINCONF_PARAM_IORESET,
/* argument: Boolean */
TEGRA_PINCONF_PARAM_RCV_SEL,
/* argument: Boolean */
TEGRA_PINCONF_PARAM_HIGH_SPEED_MODE,
/* argument: Boolean */
TEGRA_PINCONF_PARAM_SCHMITT,
/* argument: Boolean */
TEGRA_PINCONF_PARAM_LOW_POWER_MODE,
/* argument: Integer, range is HW-dependant */
TEGRA_PINCONF_PARAM_DRIVE_DOWN_STRENGTH,
/* argument: Integer, range is HW-dependant */
TEGRA_PINCONF_PARAM_DRIVE_UP_STRENGTH,
/* argument: Integer, range is HW-dependant */
TEGRA_PINCONF_PARAM_SLEW_RATE_FALLING,
/* argument: Integer, range is HW-dependant */
TEGRA_PINCONF_PARAM_SLEW_RATE_RISING,
/* argument: Integer, range is HW-dependant */
TEGRA_PINCONF_PARAM_DRIVE_TYPE,
};
enum tegra_pinconf_pull {
TEGRA_PINCONFIG_PULL_NONE,
TEGRA_PINCONFIG_PULL_DOWN,
TEGRA_PINCONFIG_PULL_UP,
};
enum tegra_pinconf_tristate {
TEGRA_PINCONFIG_DRIVEN,
TEGRA_PINCONFIG_TRISTATE,
};
#define TEGRA_PINCONF_PACK(_param_, _arg_) ((_param_) << 16 | (_arg_))
#define TEGRA_PINCONF_UNPACK_PARAM(_conf_) ((_conf_) >> 16)
#define TEGRA_PINCONF_UNPACK_ARG(_conf_) ((_conf_) & 0xffff)
/**
* struct tegra_function - Tegra pinctrl mux function
* @name: The name of the function, exported to pinctrl core.
* @groups: An array of pin groups that may select this function.
* @ngroups: The number of entries in @groups.
*/
struct tegra_function {
const char *name;
const char **groups;
unsigned ngroups;
};
/**
* struct tegra_pingroup - Tegra pin group
* @name The name of the pin group.
* @pins An array of pin IDs included in this pin group.
* @npins The number of entries in @pins.
* @funcs The mux functions which can be muxed onto this group.
* @mux_reg: Mux register offset.
* This register contains the mux, einput, odrain, lock,
* ioreset, rcv_sel parameters.
* @mux_bank: Mux register bank.
* @mux_bit: Mux register bit.
* @pupd_reg: Pull-up/down register offset.
* @pupd_bank: Pull-up/down register bank.
* @pupd_bit: Pull-up/down register bit.
* @tri_reg: Tri-state register offset.
* @tri_bank: Tri-state register bank.
* @tri_bit: Tri-state register bit.
* @einput_bit: Enable-input register bit.
* @odrain_bit: Open-drain register bit.
* @lock_bit: Lock register bit.
* @ioreset_bit: IO reset register bit.
* @rcv_sel_bit: Receiver select bit.
* @drv_reg: Drive fields register offset.
* This register contains hsm, schmitt, lpmd, drvdn,
* drvup, slwr, slwf, and drvtype parameters.
* @drv_bank: Drive fields register bank.
* @hsm_bit: High Speed Mode register bit.
* @schmitt_bit: Scmitt register bit.
* @lpmd_bit: Low Power Mode register bit.
* @drvdn_bit: Drive Down register bit.
* @drvdn_width: Drive Down field width.
* @drvup_bit: Drive Up register bit.
* @drvup_width: Drive Up field width.
* @slwr_bit: Slew Rising register bit.
* @slwr_width: Slew Rising field width.
* @slwf_bit: Slew Falling register bit.
* @slwf_width: Slew Falling field width.
* @drvtype_bit: Drive type register bit.
* @parked_bitmask: Parked register mask. 0 if unsupported.
*
* -1 in a *_reg field means that feature is unsupported for this group.
* *_bank and *_reg values are irrelevant when *_reg is -1.
* When *_reg is valid, *_bit may be -1 to indicate an unsupported feature.
*
* A representation of a group of pins (possibly just one pin) in the Tegra
* pin controller. Each group allows some parameter or parameters to be
* configured. The most common is mux function selection. Many others exist
* such as pull-up/down, tri-state, etc. Tegra's pin controller is complex;
* certain groups may only support configuring certain parameters, hence
* each parameter is optional.
*/
struct tegra_pingroup {
const char *name;
const unsigned *pins;
u8 npins;
u8 funcs[4];
s32 mux_reg;
s32 pupd_reg;
s32 tri_reg;
s32 drv_reg;
u32 mux_bank:2;
u32 pupd_bank:2;
u32 tri_bank:2;
u32 drv_bank:2;
s32 mux_bit:6;
s32 pupd_bit:6;
s32 tri_bit:6;
s32 einput_bit:6;
s32 odrain_bit:6;
s32 lock_bit:6;
s32 ioreset_bit:6;
s32 rcv_sel_bit:6;
s32 hsm_bit:6;
s32 schmitt_bit:6;
s32 lpmd_bit:6;
s32 drvdn_bit:6;
s32 drvup_bit:6;
s32 slwr_bit:6;
s32 slwf_bit:6;
s32 drvtype_bit:6;
s32 drvdn_width:6;
s32 drvup_width:6;
s32 slwr_width:6;
s32 slwf_width:6;
u32 parked_bitmask;
};
/**
* struct tegra_pinctrl_soc_data - Tegra pin controller driver configuration
* @ngpios: The number of GPIO pins the pin controller HW affects.
* @pins: An array describing all pins the pin controller affects.
* All pins which are also GPIOs must be listed first within the
* array, and be numbered identically to the GPIO controller's
* numbering.
* @npins: The numbmer of entries in @pins.
* @functions: An array describing all mux functions the SoC supports.
* @nfunctions: The numbmer of entries in @functions.
* @groups: An array describing all pin groups the pin SoC supports.
* @ngroups: The numbmer of entries in @groups.
*/
struct tegra_pinctrl_soc_data {
unsigned ngpios;
const char *gpio_compatible;
const struct pinctrl_pin_desc *pins;
unsigned npins;
struct tegra_function *functions;
unsigned nfunctions;
const struct tegra_pingroup *groups;
unsigned ngroups;
bool hsm_in_mux;
bool schmitt_in_mux;
bool drvtype_in_mux;
};
extern const struct dev_pm_ops tegra_pinctrl_pm;
int tegra_pinctrl_probe(struct platform_device *pdev,
const struct tegra_pinctrl_soc_data *soc_data);
#endif