384912ed19
The Ethernet framing is used for a lot of devices these days. Most prominent are WiFi and WiMAX based devices. However for userspace application it is important to classify these devices correctly and not only see them as Ethernet devices. The daemons like HAL, DeviceKit or even NetworkManager with udev support tries to do the classification in userspace with a lot trickery and extra system calls. This is not good and actually reaches its limitations. Especially since the kernel does know the type of the Ethernet device it is pretty stupid. To solve this problem the underlying device type needs to be set and then the value will be exported as DEVTYPE via uevents and available within udev. # cat /sys/class/net/wlan0/uevent DEVTYPE=wlan INTERFACE=wlan0 IFINDEX=5 This is similar to subsystems like USB and SCSI that distinguish between hosts, devices, disks, partitions etc. The new SET_NETDEV_DEVTYPE() is a convenience helper to set the actual device type. All device types are free form, but for convenience the same strings as used with RFKILL are choosen. Signed-off-by: Marcel Holtmann <marcel@holtmann.org> Signed-off-by: David S. Miller <davem@davemloft.net> |
||
|---|---|---|
| .. | ||
| control.c | ||
| debug-levels.h | ||
| debugfs.c | ||
| driver.c | ||
| fw.c | ||
| i2400m-sdio.h | ||
| i2400m-usb.h | ||
| i2400m.h | ||
| Kconfig | ||
| Makefile | ||
| netdev.c | ||
| op-rfkill.c | ||
| rx.c | ||
| sdio-debug-levels.h | ||
| sdio-fw.c | ||
| sdio-rx.c | ||
| sdio-tx.c | ||
| sdio.c | ||
| sysfs.c | ||
| tx.c | ||
| usb-debug-levels.h | ||
| usb-fw.c | ||
| usb-notif.c | ||
| usb-rx.c | ||
| usb-tx.c | ||
| usb.c | ||