d1a277c584
This patch adds a generic driver for SJA1000 chips on the OpenFirmware platform bus found on embedded PowerPC systems. You need a SJA1000 node definition in your flattened device tree source (DTS) file similar to: can@3,100 { compatible = "nxp,sja1000"; reg = <3 0x100 0x80>; interrupts = <2 0>; interrupt-parent = <&mpic>; nxp,external-clock-frequency = <16000000>; }; See also Documentation/powerpc/dts-bindings/can/sja1000.txt. CC: devicetree-discuss@ozlabs.org Signed-off-by: Wolfgang Grandegger <wg@grandegger.com> Signed-off-by: David S. Miller <davem@davemloft.net>
36 lines
1.0 KiB
C
36 lines
1.0 KiB
C
#ifndef _CAN_PLATFORM_SJA1000_H_
|
|
#define _CAN_PLATFORM_SJA1000_H_
|
|
|
|
/* clock divider register */
|
|
#define CDR_CLKOUT_MASK 0x07
|
|
#define CDR_CLK_OFF 0x08 /* Clock off (CLKOUT pin) */
|
|
#define CDR_RXINPEN 0x20 /* TX1 output is RX irq output */
|
|
#define CDR_CBP 0x40 /* CAN input comparator bypass */
|
|
#define CDR_PELICAN 0x80 /* PeliCAN mode */
|
|
|
|
/* output control register */
|
|
#define OCR_MODE_BIPHASE 0x00
|
|
#define OCR_MODE_TEST 0x01
|
|
#define OCR_MODE_NORMAL 0x02
|
|
#define OCR_MODE_CLOCK 0x03
|
|
#define OCR_MODE_MASK 0x07
|
|
#define OCR_TX0_INVERT 0x04
|
|
#define OCR_TX0_PULLDOWN 0x08
|
|
#define OCR_TX0_PULLUP 0x10
|
|
#define OCR_TX0_PUSHPULL 0x18
|
|
#define OCR_TX1_INVERT 0x20
|
|
#define OCR_TX1_PULLDOWN 0x40
|
|
#define OCR_TX1_PULLUP 0x80
|
|
#define OCR_TX1_PUSHPULL 0xc0
|
|
#define OCR_TX_MASK 0xfc
|
|
#define OCR_TX_SHIFT 2
|
|
|
|
struct sja1000_platform_data {
|
|
u32 clock; /* CAN bus oscillator frequency in Hz */
|
|
|
|
u8 ocr; /* output control register */
|
|
u8 cdr; /* clock divider register */
|
|
};
|
|
|
|
#endif /* !_CAN_PLATFORM_SJA1000_H_ */
|