android_kernel_xiaomi_sm8350/Documentation/sound/oss/CMI8338
Linus Torvalds 1da177e4c3 Linux-2.6.12-rc2
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!
2005-04-16 15:20:36 -07:00

86 lines
2.8 KiB
Plaintext

Audio driver for CM8338/CM8738 chips by Chen-Li Tien
HARDWARE SUPPORTED
================================================================================
C-Media CMI8338
C-Media CMI8738
On-board C-Media chips
STEPS TO BUILD DRIVER
================================================================================
1. Backup the Config.in and Makefile in the sound driver directory
(/usr/src/linux/driver/sound).
The Configure.help provide help when you config driver in step
4, please backup the original one (/usr/src/linux/Document) and
copy this file.
The cmpci is document for the driver in detail, please copy it
to /usr/src/linux/Document/sound so you can refer it. Backup if
there is already one.
2. Extract the tar file by 'tar xvzf cmpci-xx.tar.gz' in the above
directory.
3. Change directory to /usr/src/linux
4. Config cm8338 driver by 'make menuconfig', 'make config' or
'make xconfig' command.
5. Please select Sound Card (CONFIG_SOUND=m) support and CMPCI
driver (CONFIG_SOUND_CMPCI=m) as modules. Resident mode not tested.
For driver option, please refer 'DRIVER PARAMETER'
6. Compile the kernel if necessary.
7. Compile the modules by 'make modules'.
8. Install the modules by 'make modules_install'
INSTALL DRIVER
================================================================================
1. Before first time to run the driver, create module dependency by
'depmod -a'
2. To install the driver manually, enter 'modprobe cmpci'.
3. Driver installation for various distributions:
a. Slackware 4.0
Add the 'modprobe cmpci' command in your /etc/rc.d/rc.modules
file.so you can start the driver automatically each time booting.
b. Caldera OpenLinux 2.2
Use LISA to load the cmpci module.
c. RedHat 6.0 and S.u.S.E. 6.1
Add following command in /etc/conf.modules:
alias sound cmpci
also visit http://www.cmedia.com.tw for installation instruction.
DRIVER PARAMETER
================================================================================
Some functions for the cm8738 can be configured in Kernel Configuration
or modules parameters. Set these parameters to 1 to enable.
mpuio: I/O ports base for MPU-401, 0 if disabled.
fmio: I/O ports base for OPL-3, 0 if disabled.
spdif_inverse:Inverse the S/PDIF-in signal, this depends on your
CD-ROM or DVD-ROM.
spdif_loop: Enable S/PDIF loop, this route S/PDIF-in to S/PDIF-out
directly.
speakers: Number of speakers used.
use_line_as_rear:Enable this if you want to use line-in as
rear-out.
use_line_as_bass:Enable this if you want to use line-in as
bass-out.
joystick: Enable joystick. You will need to install Linux joystick
driver.