0314b020c4
There is no point in implementing a detect callback for the DS2482, as this device can't be detected. It was there solely to handle "force" module parameters to instantiate devices, but now we have a better sysfs interface that can do the same. So we can get rid of the ugly module parameters and the detect callback. This shrinks the binary module size by 21%. Signed-off-by: Jean Delvare <khali@linux-fr.org> Acked-by: Ben Gardner <gardner.ben@gmail.com>
32 lines
798 B
Plaintext
32 lines
798 B
Plaintext
Kernel driver ds2482
|
|
====================
|
|
|
|
Supported chips:
|
|
* Maxim DS2482-100, Maxim DS2482-800
|
|
Prefix: 'ds2482'
|
|
Addresses scanned: None
|
|
Datasheets:
|
|
http://pdfserv.maxim-ic.com/en/ds/DS2482-100-DS2482S-100.pdf
|
|
http://pdfserv.maxim-ic.com/en/ds/DS2482-800-DS2482S-800.pdf
|
|
|
|
Author: Ben Gardner <bgardner@wabtec.com>
|
|
|
|
|
|
Description
|
|
-----------
|
|
|
|
The Maxim/Dallas Semiconductor DS2482 is a I2C device that provides
|
|
one (DS2482-100) or eight (DS2482-800) 1-wire busses.
|
|
|
|
|
|
General Remarks
|
|
---------------
|
|
|
|
Valid addresses are 0x18, 0x19, 0x1a, and 0x1b.
|
|
However, the device cannot be detected without writing to the i2c bus, so no
|
|
detection is done. You should instantiate the device explicitly.
|
|
|
|
$ modprobe ds2482
|
|
$ echo ds2482 0x18 > /sys/bus/i2c/devices/i2c-0/new_device
|
|
|