09c434b8a0
Add SPDX license identifiers to all files which: - Have no license information of any form - Have MODULE_LICENCE("GPL*") inside which was used in the initial scan/conversion to ignore the file These files fall under the project license, GPL v2 only. The resulting SPDX license identifier is: GPL-2.0-only Signed-off-by: Thomas Gleixner <tglx@linutronix.de> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
263 lines
6.0 KiB
C
263 lines
6.0 KiB
C
// SPDX-License-Identifier: GPL-2.0-only
|
|
/*
|
|
* drivers/mtd/maps/ixp4xx.c
|
|
*
|
|
* MTD Map file for IXP4XX based systems. Please do not make per-board
|
|
* changes in here. If your board needs special setup, do it in your
|
|
* platform level code in arch/arm/mach-ixp4xx/board-setup.c
|
|
*
|
|
* Original Author: Intel Corporation
|
|
* Maintainer: Deepak Saxena <dsaxena@mvista.com>
|
|
*
|
|
* Copyright (C) 2002 Intel Corporation
|
|
* Copyright (C) 2003-2004 MontaVista Software, Inc.
|
|
*
|
|
*/
|
|
|
|
#include <linux/err.h>
|
|
#include <linux/module.h>
|
|
#include <linux/types.h>
|
|
#include <linux/kernel.h>
|
|
#include <linux/string.h>
|
|
#include <linux/slab.h>
|
|
#include <linux/ioport.h>
|
|
#include <linux/device.h>
|
|
#include <linux/platform_device.h>
|
|
|
|
#include <linux/mtd/mtd.h>
|
|
#include <linux/mtd/map.h>
|
|
#include <linux/mtd/partitions.h>
|
|
|
|
#include <asm/io.h>
|
|
#include <asm/mach/flash.h>
|
|
|
|
#include <linux/reboot.h>
|
|
|
|
/*
|
|
* Read/write a 16 bit word from flash address 'addr'.
|
|
*
|
|
* When the cpu is in little-endian mode it swizzles the address lines
|
|
* ('address coherency') so we need to undo the swizzling to ensure commands
|
|
* and the like end up on the correct flash address.
|
|
*
|
|
* To further complicate matters, due to the way the expansion bus controller
|
|
* handles 32 bit reads, the byte stream ABCD is stored on the flash as:
|
|
* D15 D0
|
|
* +---+---+
|
|
* | A | B | 0
|
|
* +---+---+
|
|
* | C | D | 2
|
|
* +---+---+
|
|
* This means that on LE systems each 16 bit word must be swapped. Note that
|
|
* this requires CONFIG_MTD_CFI_BE_BYTE_SWAP to be enabled to 'unswap' the CFI
|
|
* data and other flash commands which are always in D7-D0.
|
|
*/
|
|
#ifndef __ARMEB__
|
|
#ifndef CONFIG_MTD_CFI_BE_BYTE_SWAP
|
|
# error CONFIG_MTD_CFI_BE_BYTE_SWAP required
|
|
#endif
|
|
|
|
static inline u16 flash_read16(void __iomem *addr)
|
|
{
|
|
return be16_to_cpu(__raw_readw((void __iomem *)((unsigned long)addr ^ 0x2)));
|
|
}
|
|
|
|
static inline void flash_write16(u16 d, void __iomem *addr)
|
|
{
|
|
__raw_writew(cpu_to_be16(d), (void __iomem *)((unsigned long)addr ^ 0x2));
|
|
}
|
|
|
|
#define BYTE0(h) ((h) & 0xFF)
|
|
#define BYTE1(h) (((h) >> 8) & 0xFF)
|
|
|
|
#else
|
|
|
|
static inline u16 flash_read16(const void __iomem *addr)
|
|
{
|
|
return __raw_readw(addr);
|
|
}
|
|
|
|
static inline void flash_write16(u16 d, void __iomem *addr)
|
|
{
|
|
__raw_writew(d, addr);
|
|
}
|
|
|
|
#define BYTE0(h) (((h) >> 8) & 0xFF)
|
|
#define BYTE1(h) ((h) & 0xFF)
|
|
#endif
|
|
|
|
static map_word ixp4xx_read16(struct map_info *map, unsigned long ofs)
|
|
{
|
|
map_word val;
|
|
val.x[0] = flash_read16(map->virt + ofs);
|
|
return val;
|
|
}
|
|
|
|
/*
|
|
* The IXP4xx expansion bus only allows 16-bit wide acceses
|
|
* when attached to a 16-bit wide device (such as the 28F128J3A),
|
|
* so we can't just memcpy_fromio().
|
|
*/
|
|
static void ixp4xx_copy_from(struct map_info *map, void *to,
|
|
unsigned long from, ssize_t len)
|
|
{
|
|
u8 *dest = (u8 *) to;
|
|
void __iomem *src = map->virt + from;
|
|
|
|
if (len <= 0)
|
|
return;
|
|
|
|
if (from & 1) {
|
|
*dest++ = BYTE1(flash_read16(src-1));
|
|
src++;
|
|
--len;
|
|
}
|
|
|
|
while (len >= 2) {
|
|
u16 data = flash_read16(src);
|
|
*dest++ = BYTE0(data);
|
|
*dest++ = BYTE1(data);
|
|
src += 2;
|
|
len -= 2;
|
|
}
|
|
|
|
if (len > 0)
|
|
*dest++ = BYTE0(flash_read16(src));
|
|
}
|
|
|
|
/*
|
|
* Unaligned writes are ignored, causing the 8-bit
|
|
* probe to fail and proceed to the 16-bit probe (which succeeds).
|
|
*/
|
|
static void ixp4xx_probe_write16(struct map_info *map, map_word d, unsigned long adr)
|
|
{
|
|
if (!(adr & 1))
|
|
flash_write16(d.x[0], map->virt + adr);
|
|
}
|
|
|
|
/*
|
|
* Fast write16 function without the probing check above
|
|
*/
|
|
static void ixp4xx_write16(struct map_info *map, map_word d, unsigned long adr)
|
|
{
|
|
flash_write16(d.x[0], map->virt + adr);
|
|
}
|
|
|
|
struct ixp4xx_flash_info {
|
|
struct mtd_info *mtd;
|
|
struct map_info map;
|
|
struct resource *res;
|
|
};
|
|
|
|
static const char * const probes[] = { "RedBoot", "cmdlinepart", NULL };
|
|
|
|
static int ixp4xx_flash_remove(struct platform_device *dev)
|
|
{
|
|
struct flash_platform_data *plat = dev_get_platdata(&dev->dev);
|
|
struct ixp4xx_flash_info *info = platform_get_drvdata(dev);
|
|
|
|
if(!info)
|
|
return 0;
|
|
|
|
if (info->mtd) {
|
|
mtd_device_unregister(info->mtd);
|
|
map_destroy(info->mtd);
|
|
}
|
|
|
|
if (plat->exit)
|
|
plat->exit();
|
|
|
|
return 0;
|
|
}
|
|
|
|
static int ixp4xx_flash_probe(struct platform_device *dev)
|
|
{
|
|
struct flash_platform_data *plat = dev_get_platdata(&dev->dev);
|
|
struct ixp4xx_flash_info *info;
|
|
struct mtd_part_parser_data ppdata = {
|
|
.origin = dev->resource->start,
|
|
};
|
|
int err = -1;
|
|
|
|
if (!plat)
|
|
return -ENODEV;
|
|
|
|
if (plat->init) {
|
|
err = plat->init();
|
|
if (err)
|
|
return err;
|
|
}
|
|
|
|
info = devm_kzalloc(&dev->dev, sizeof(struct ixp4xx_flash_info),
|
|
GFP_KERNEL);
|
|
if(!info) {
|
|
err = -ENOMEM;
|
|
goto Error;
|
|
}
|
|
|
|
platform_set_drvdata(dev, info);
|
|
|
|
/*
|
|
* Tell the MTD layer we're not 1:1 mapped so that it does
|
|
* not attempt to do a direct access on us.
|
|
*/
|
|
info->map.phys = NO_XIP;
|
|
info->map.size = resource_size(dev->resource);
|
|
|
|
/*
|
|
* We only support 16-bit accesses for now. If and when
|
|
* any board use 8-bit access, we'll fixup the driver to
|
|
* handle that.
|
|
*/
|
|
info->map.bankwidth = 2;
|
|
info->map.name = dev_name(&dev->dev);
|
|
info->map.read = ixp4xx_read16;
|
|
info->map.write = ixp4xx_probe_write16;
|
|
info->map.copy_from = ixp4xx_copy_from;
|
|
|
|
info->map.virt = devm_ioremap_resource(&dev->dev, dev->resource);
|
|
if (IS_ERR(info->map.virt)) {
|
|
err = PTR_ERR(info->map.virt);
|
|
goto Error;
|
|
}
|
|
|
|
info->mtd = do_map_probe(plat->map_name, &info->map);
|
|
if (!info->mtd) {
|
|
printk(KERN_ERR "IXP4XXFlash: map_probe failed\n");
|
|
err = -ENXIO;
|
|
goto Error;
|
|
}
|
|
info->mtd->dev.parent = &dev->dev;
|
|
|
|
/* Use the fast version */
|
|
info->map.write = ixp4xx_write16;
|
|
|
|
err = mtd_device_parse_register(info->mtd, probes, &ppdata,
|
|
plat->parts, plat->nr_parts);
|
|
if (err) {
|
|
printk(KERN_ERR "Could not parse partitions\n");
|
|
goto Error;
|
|
}
|
|
|
|
return 0;
|
|
|
|
Error:
|
|
ixp4xx_flash_remove(dev);
|
|
return err;
|
|
}
|
|
|
|
static struct platform_driver ixp4xx_flash_driver = {
|
|
.probe = ixp4xx_flash_probe,
|
|
.remove = ixp4xx_flash_remove,
|
|
.driver = {
|
|
.name = "IXP4XX-Flash",
|
|
},
|
|
};
|
|
|
|
module_platform_driver(ixp4xx_flash_driver);
|
|
|
|
MODULE_LICENSE("GPL");
|
|
MODULE_DESCRIPTION("MTD map driver for Intel IXP4xx systems");
|
|
MODULE_AUTHOR("Deepak Saxena");
|
|
MODULE_ALIAS("platform:IXP4XX-Flash");
|