android_kernel_xiaomi_sm8350/drivers/scsi/qla2xxx/qla_settings.h
Linus Torvalds 1da177e4c3 Linux-2.6.12-rc2
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.

Let it rip!
2005-04-16 15:20:36 -07:00

65 lines
2.1 KiB
C

/******************************************************************************
* QLOGIC LINUX SOFTWARE
*
* QLogic ISP2x00 device driver for Linux 2.6.x
* Copyright (C) 2003-2004 QLogic Corporation
* (www.qlogic.com)
*
* This program is free software; you can redistribute it and/or modify it
* under the terms of the GNU General Public License as published by the
* Free Software Foundation; either version 2, or (at your option) any
* later version.
*
* This program is distributed in the hope that it will be useful, but
* WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU
* General Public License for more details.
*
******************************************************************************/
/*
* Compile time Options:
* 0 - Disable and 1 - Enable
*/
#define DEBUG_QLA2100 0 /* For Debug of qla2x00 */
#define STOP_ON_RESET 0
#define USE_ABORT_TGT 1 /* Use Abort Target mbx cmd */
#define VSA 0 /* Volume Set Addressing */
/* Failover options */
#define MAX_RECOVERYTIME 10 /*
* Max suspend time for a lun recovery
* time
*/
#define MAX_FAILBACKTIME 5 /* Max suspend time before fail back */
#define QLA_CMD_TIMER_DELTA 3
/*
* When a lun is suspended for the "Not Ready" condition then it will suspend
* the lun for increments of 6 sec delays. SUSPEND_COUNT is that count.
*/
#define SUSPEND_COUNT 10 /* 6 secs * 10 retries = 60 secs */
/*
* Defines the time in seconds that the driver extends the command timeout to
* get around the problem where the mid-layer only allows 5 retries for
* commands that return BUS_BUSY
*/
#define EXTEND_CMD_TIMEOUT 60
#define MAX_RETRIES_OF_ISP_ABORT 5
/* Max time to wait for the loop to be in LOOP_READY state */
#define MAX_LOOP_TIMEOUT (60 * 5)
#define EH_ACTIVE 1 /* Error handler active */
/*
* Some vendor subsystems do not recover properly after a device reset. Define
* the following to force a logout after a successful device reset.
*/
#undef LOGOUT_AFTER_DEVICE_RESET
#include "qla_version.h"