e24c745272
Driver for the Designware SPI core, it supports multipul interfaces like PCI/APB etc. User can use "dw_apb_ssi_db.pdf" from Synopsys as HW datasheet. [randy.dunlap@oracle.com: fix build] [akpm@linux-foundation.org: build fix] Signed-off-by: Feng Tang <feng.tang@intel.com> Cc: David Brownell <david-b@pacbell.net> Signed-off-by: Randy Dunlap <randy.dunlap@oracle.com> Signed-off-by: Andrew Morton <akpm@linux-foundation.org> Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
213 lines
4.8 KiB
C
213 lines
4.8 KiB
C
#ifndef DW_SPI_HEADER_H
|
|
#define DW_SPI_HEADER_H
|
|
#include <linux/io.h>
|
|
|
|
/* Bit fields in CTRLR0 */
|
|
#define SPI_DFS_OFFSET 0
|
|
|
|
#define SPI_FRF_OFFSET 4
|
|
#define SPI_FRF_SPI 0x0
|
|
#define SPI_FRF_SSP 0x1
|
|
#define SPI_FRF_MICROWIRE 0x2
|
|
#define SPI_FRF_RESV 0x3
|
|
|
|
#define SPI_MODE_OFFSET 6
|
|
#define SPI_SCPH_OFFSET 6
|
|
#define SPI_SCOL_OFFSET 7
|
|
#define SPI_TMOD_OFFSET 8
|
|
#define SPI_TMOD_TR 0x0 /* xmit & recv */
|
|
#define SPI_TMOD_TO 0x1 /* xmit only */
|
|
#define SPI_TMOD_RO 0x2 /* recv only */
|
|
#define SPI_TMOD_EPROMREAD 0x3 /* eeprom read mode */
|
|
|
|
#define SPI_SLVOE_OFFSET 10
|
|
#define SPI_SRL_OFFSET 11
|
|
#define SPI_CFS_OFFSET 12
|
|
|
|
/* Bit fields in SR, 7 bits */
|
|
#define SR_MASK 0x7f /* cover 7 bits */
|
|
#define SR_BUSY (1 << 0)
|
|
#define SR_TF_NOT_FULL (1 << 1)
|
|
#define SR_TF_EMPT (1 << 2)
|
|
#define SR_RF_NOT_EMPT (1 << 3)
|
|
#define SR_RF_FULL (1 << 4)
|
|
#define SR_TX_ERR (1 << 5)
|
|
#define SR_DCOL (1 << 6)
|
|
|
|
/* Bit fields in ISR, IMR, RISR, 7 bits */
|
|
#define SPI_INT_TXEI (1 << 0)
|
|
#define SPI_INT_TXOI (1 << 1)
|
|
#define SPI_INT_RXUI (1 << 2)
|
|
#define SPI_INT_RXOI (1 << 3)
|
|
#define SPI_INT_RXFI (1 << 4)
|
|
#define SPI_INT_MSTI (1 << 5)
|
|
|
|
/* TX RX interrupt level threshhold, max can be 256 */
|
|
#define SPI_INT_THRESHOLD 32
|
|
|
|
enum dw_ssi_type {
|
|
SSI_MOTO_SPI = 0,
|
|
SSI_TI_SSP,
|
|
SSI_NS_MICROWIRE,
|
|
};
|
|
|
|
struct dw_spi_reg {
|
|
u32 ctrl0;
|
|
u32 ctrl1;
|
|
u32 ssienr;
|
|
u32 mwcr;
|
|
u32 ser;
|
|
u32 baudr;
|
|
u32 txfltr;
|
|
u32 rxfltr;
|
|
u32 txflr;
|
|
u32 rxflr;
|
|
u32 sr;
|
|
u32 imr;
|
|
u32 isr;
|
|
u32 risr;
|
|
u32 txoicr;
|
|
u32 rxoicr;
|
|
u32 rxuicr;
|
|
u32 msticr;
|
|
u32 icr;
|
|
u32 dmacr;
|
|
u32 dmatdlr;
|
|
u32 dmardlr;
|
|
u32 idr;
|
|
u32 version;
|
|
u32 dr; /* Currently oper as 32 bits,
|
|
though only low 16 bits matters */
|
|
} __packed;
|
|
|
|
struct dw_spi {
|
|
struct spi_master *master;
|
|
struct spi_device *cur_dev;
|
|
struct device *parent_dev;
|
|
enum dw_ssi_type type;
|
|
|
|
void __iomem *regs;
|
|
unsigned long paddr;
|
|
u32 iolen;
|
|
int irq;
|
|
u32 max_freq; /* max bus freq supported */
|
|
|
|
u16 bus_num;
|
|
u16 num_cs; /* supported slave numbers */
|
|
|
|
/* Driver message queue */
|
|
struct workqueue_struct *workqueue;
|
|
struct work_struct pump_messages;
|
|
spinlock_t lock;
|
|
struct list_head queue;
|
|
int busy;
|
|
int run;
|
|
|
|
/* Message Transfer pump */
|
|
struct tasklet_struct pump_transfers;
|
|
|
|
/* Current message transfer state info */
|
|
struct spi_message *cur_msg;
|
|
struct spi_transfer *cur_transfer;
|
|
struct chip_data *cur_chip;
|
|
struct chip_data *prev_chip;
|
|
size_t len;
|
|
void *tx;
|
|
void *tx_end;
|
|
void *rx;
|
|
void *rx_end;
|
|
int dma_mapped;
|
|
dma_addr_t rx_dma;
|
|
dma_addr_t tx_dma;
|
|
size_t rx_map_len;
|
|
size_t tx_map_len;
|
|
u8 n_bytes; /* current is a 1/2 bytes op */
|
|
u8 max_bits_per_word; /* maxim is 16b */
|
|
u32 dma_width;
|
|
int cs_change;
|
|
int (*write)(struct dw_spi *dws);
|
|
int (*read)(struct dw_spi *dws);
|
|
irqreturn_t (*transfer_handler)(struct dw_spi *dws);
|
|
void (*cs_control)(u32 command);
|
|
|
|
/* Dma info */
|
|
int dma_inited;
|
|
struct dma_chan *txchan;
|
|
struct dma_chan *rxchan;
|
|
int txdma_done;
|
|
int rxdma_done;
|
|
u64 tx_param;
|
|
u64 rx_param;
|
|
struct device *dma_dev;
|
|
dma_addr_t dma_addr;
|
|
|
|
/* Bus interface info */
|
|
void *priv;
|
|
#ifdef CONFIG_DEBUG_FS
|
|
struct dentry *debugfs;
|
|
#endif
|
|
};
|
|
|
|
#define dw_readl(dw, name) \
|
|
__raw_readl(&(((struct dw_spi_reg *)dw->regs)->name))
|
|
#define dw_writel(dw, name, val) \
|
|
__raw_writel((val), &(((struct dw_spi_reg *)dw->regs)->name))
|
|
#define dw_readw(dw, name) \
|
|
__raw_readw(&(((struct dw_spi_reg *)dw->regs)->name))
|
|
#define dw_writew(dw, name, val) \
|
|
__raw_writew((val), &(((struct dw_spi_reg *)dw->regs)->name))
|
|
|
|
static inline void spi_enable_chip(struct dw_spi *dws, int enable)
|
|
{
|
|
dw_writel(dws, ssienr, (enable ? 1 : 0));
|
|
}
|
|
|
|
static inline void spi_set_clk(struct dw_spi *dws, u16 div)
|
|
{
|
|
dw_writel(dws, baudr, div);
|
|
}
|
|
|
|
static inline void spi_chip_sel(struct dw_spi *dws, u16 cs)
|
|
{
|
|
if (cs > dws->num_cs)
|
|
return;
|
|
dw_writel(dws, ser, 1 << cs);
|
|
}
|
|
|
|
/* Disable IRQ bits */
|
|
static inline void spi_mask_intr(struct dw_spi *dws, u32 mask)
|
|
{
|
|
u32 new_mask;
|
|
|
|
new_mask = dw_readl(dws, imr) & ~mask;
|
|
dw_writel(dws, imr, new_mask);
|
|
}
|
|
|
|
/* Enable IRQ bits */
|
|
static inline void spi_umask_intr(struct dw_spi *dws, u32 mask)
|
|
{
|
|
u32 new_mask;
|
|
|
|
new_mask = dw_readl(dws, imr) | mask;
|
|
dw_writel(dws, imr, new_mask);
|
|
}
|
|
|
|
/*
|
|
* Each SPI slave device to work with dw_api controller should
|
|
* has such a structure claiming its working mode (PIO/DMA etc),
|
|
* which can be save in the "controller_data" member of the
|
|
* struct spi_device
|
|
*/
|
|
struct dw_spi_chip {
|
|
u8 poll_mode; /* 0 for contoller polling mode */
|
|
u8 type; /* SPI/SSP/Micrwire */
|
|
u8 enable_dma;
|
|
void (*cs_control)(u32 command);
|
|
};
|
|
|
|
extern int dw_spi_add_host(struct dw_spi *dws);
|
|
extern void dw_spi_remove_host(struct dw_spi *dws);
|
|
extern int dw_spi_suspend_host(struct dw_spi *dws);
|
|
extern int dw_spi_resume_host(struct dw_spi *dws);
|
|
#endif /* DW_SPI_HEADER_H */
|