mirror of
https://github.com/saitohirga/WSJT-X.git
synced 2024-09-27 15:46:51 -04:00
47 lines
2.7 KiB
Plaintext
47 lines
2.7 KiB
Plaintext
|
// Status=review
|
||
|
|
||
|
JT65 was designed for making minimal QSOs via EME (``moon-bounce'') on
|
||
|
the VHF and UHF bands. A detailed description of the protocol and its
|
||
|
implementation in program _WSJT_ was published in {jt65protocol} for
|
||
|
September-October, 2005. Briefly stated, JT65 uses 60 s T/R sequences
|
||
|
and carefully structured messages. Standard messages are compressed
|
||
|
so that two callsigns and a grid locator can be transmitted with just
|
||
|
71 bits. A 72^nd^ bit serves as a flag to indicate that the message
|
||
|
consists of arbitrary text (up to 13 characters) instead of callsigns
|
||
|
and a grid locator. Special formats allow other information such as
|
||
|
add-on callsign prefixes (e.g., ZA/K1ABC) or numerical signal reports
|
||
|
(in dB) to be substituted for the grid locator. The aim of source
|
||
|
encoding is to compress the common messages used for minimal QSOs into
|
||
|
a minimum fixed number of bits. After compression, a Reed Solomon
|
||
|
(63,12) error-correcting code converts 72-bit user messages into
|
||
|
sequences of 63 six-bit channel symbols.
|
||
|
|
||
|
JT65 requires tight synchronization of time and frequency between
|
||
|
transmitter and receiver. Each transmission is divided into 126
|
||
|
contiguous time intervals or symbols, each of length 4096/11025 =
|
||
|
0.372 s. Within each interval the waveform is a constant-amplitude
|
||
|
sinusoid at one of 65 pre-defined frequencies. Frequency steps
|
||
|
between intervals are accomplished in a phase-continuous manner. Half
|
||
|
of the channel symbols are devoted to a pseudo-random synchronizing
|
||
|
vector interleaved with the encoded information symbols. The sync
|
||
|
vector allows calibration of time and frequency offsets between
|
||
|
transmitter and receiver. A transmission nominally begins at t = 1 s
|
||
|
after the start of a UTC minute and finishes at t = 47.8 s. The
|
||
|
synchronizing tone is at 11025*472/4096 = 1270.5 Hz, and is normally
|
||
|
sent in each interval having a “1” in the following pseudo-random
|
||
|
sequence:
|
||
|
|
||
|
100110001111110101000101100100011100111101101111000110101011001
|
||
|
101010100100000011000000011010010110101010011001001000011111111
|
||
|
|
||
|
Encoded user information is transmitted during the 63 intervals not
|
||
|
used for the sync tone. Each channel symbol generates a tone at
|
||
|
frequency 1275.8 + 2.6917 Nm Hz, where N is the value of the six-bit
|
||
|
symbol, 0 ≤ N ≤ 63, and m is 1, 2, or 4 for JT65 sub-modes A, B, or C.
|
||
|
The signal report “OOO” is conveyed by reversing sync and data
|
||
|
positions in the transmitted sequence. Shorthand messages dispense
|
||
|
with the sync vector and use intervals of 1.486 s (16,384 samples) for
|
||
|
the alternating tones. The lower frequency is always 1270.5 Hz, the
|
||
|
same as that of the sync tone, and the frequency separation is 26.92
|
||
|
nm Hz with n = 2, 3, 4 for the messages RO, RRR, and 73.
|