diff --git a/doc/user_guide/en/controls-functions-main-window.adoc b/doc/user_guide/en/controls-functions-main-window.adoc
index d5adb0647..0027100d4 100644
--- a/doc/user_guide/en/controls-functions-main-window.adoc
+++ b/doc/user_guide/en/controls-functions-main-window.adoc
@@ -11,7 +11,9 @@ image::main-ui-controls.png[align="center",width=650,alt="Main UI Controls"]
 * *Log QSO* raises a dialog window pre-filled with known information
 about a QSO you have nearly completed.  You can edit or add to this
 information before clicking *OK* to log the QSO.  If you check *Prompt
-me to log QSO* on the *File -> Settings -> Reporting* tab, the program raises the confirmation screen automatically when you send a message containing +73+.  *Start Date* and *Start Time* are set when you click
+me to log QSO* on the *File -> Settings -> Reporting* tab, the program
+raises the confirmation screen automatically when you send a message
+containing +73+.  *Start Date* and *Start Time* are set when you click
 to send the *Tx 2* or *Tx 3* message, and backed up by one or two
 sequence lengths, respectively.  (Note that the actual start time may
 have been earlier if repeats of early transmissions were required.)
diff --git a/doc/user_guide/en/vhf-features.adoc b/doc/user_guide/en/vhf-features.adoc
index 3dd1a06ae..e108cdfe4 100644
--- a/doc/user_guide/en/vhf-features.adoc
+++ b/doc/user_guide/en/vhf-features.adoc
@@ -333,6 +333,27 @@ correlation algorithm.  JT65 and Q65 offer _a priori_ (AP)
 decoding, which takes advantage of naturally accumulating information
 during a QSO.
 
+For CW mode on SHF and microwave EME WSJT-X can be used to do Doppler
+shift correction if desired:
+
+- Check the *Settings -> Radio -> Mode -> None* option, this stops _WSJT-X_
+  from trying to set the mode of your rig.
+
+- Put you rig into CW mode as normal.
+
+- Before transmitting press *Tune* in _WSJT-X_, no tones will be
+  transmitted as the rig is in CW mode, but importantly WSJT-X knows
+  your are transmitting and adjusts the Doppler shift correction as
+  needed for the currently selected Doppler shift correction mode in
+  transmit.
+
+- When you have finish transmitting CW press *Tune* again to revert to
+  receive mode and the correct Doppler shift correction for receiving.
+
+NOTE: The above assumes you are already set up for _WSJT-X_
+<<VHF_SETUP,Doppler shift correction>> with working CAT control, and
+*Monitor* enabled etc..
+
 ////
 The following tutorial aims to familiarize you with
 these program features, all of which are of special interest for EME