From e4dca8e241203641c10461057b783b94a4aaebbe Mon Sep 17 00:00:00 2001 From: Joe Taylor Date: Fri, 25 Aug 2023 10:06:25 -0400 Subject: [PATCH] Edits to User Guide concerning Echo mode. --- doc/user_guide/en/vhf-features.adoc | 20 +++++++++++--------- 1 file changed, 11 insertions(+), 9 deletions(-) diff --git a/doc/user_guide/en/vhf-features.adoc b/doc/user_guide/en/vhf-features.adoc index 54fcf2af2..f6d1c30ec 100644 --- a/doc/user_guide/en/vhf-features.adoc +++ b/doc/user_guide/en/vhf-features.adoc @@ -26,7 +26,7 @@ on bands above 1.2 GHz. To activate the VHF-and-up features: -- On the *Settings | General* tab check *Enable VHF/UHF/Microwave +- On the *Settings | General* tab check *Enable VHF and submode features* and *Single decode*. - For EME, check *Decode after EME delay* to allow for extra path @@ -291,14 +291,16 @@ communication. For lunar echoes, _WSJT_ generates short fixed-frequency transmissions that alternate with reception intervals at the appropriate -Doppler-shifted frequency. With *Split Operation* set to *Rig* or -*Fake It* on the *Settings | Radio* tab, check *Doppler tracking* and -*Own Echo* on the Astronomical Data window. Point your antenna at the -Moon and click *Enable Tx* on the main window to start a sequence of -echo measurements. Each cycle takes 6 seconds. If strong enough, -echoes will be visible in the waterfall. Their average spectrum will -be displayed in the Echo Graph window, and numerical parameters of the -measurements appear in the main window: +Doppler-shifted frequency. Be sure that *Enable VHF and submode +features* has been checked on the *Settings | General* tab. With +*Split Operation* set to *Rig* or *Fake It* on the *Settings | Radio* +tab, check *Doppler tracking* and *Own Echo* on the Astronomical Data +window. Point your antenna at the Moon and click *Enable Tx* on the +main window to start a sequence of echo measurements. Each cycle +takes 6 seconds. If strong enough, echoes will be visible in the +waterfall. Their average spectrum will be displayed in the Echo Graph +window, and numerical parameters of the measurements appear in the +main window: image::Echo_1296.png[align="center",alt="Echo 144 MHz"]