mirror of
https://github.com/saitohirga/WSJT-X.git
synced 2024-11-19 10:32:02 -05:00
92 lines
5.1 KiB
Plaintext
92 lines
5.1 KiB
Plaintext
// Status=review
|
||
|
||
_WSJT-X_ is a computer program designed to facilitate basic amateur
|
||
radio communication using very weak signals. The first four letters in
|
||
the program name stand for "`**W**eak **S**ignal communication by
|
||
K1**JT**,`" while the suffix "`*-X*`" indicates that _WSJT-X_ started
|
||
as an extended branch of an earlier program, _WSJT_, first released in
|
||
2001. Bill Somerville, G4WJS, Steve Franke, K9AN, and Nico Palermo,
|
||
IV3NWV, have been major contributors to development of _WSJT-X_ since
|
||
2013, 2015, and 2016, respectively.
|
||
|
||
_WSJT-X_ Version {VERSION_MAJOR}.{VERSION_MINOR} offers eleven
|
||
different protocols or modes: *FST4*, *FT4*, *FT8*, *JT4*, *JT9*,
|
||
*JT65*, *Q65*, *MSK144*, *WSPR*, *FST4W*, and *Echo*. The first seven
|
||
are designed for making reliable QSOs under weak-signal
|
||
conditions. They use nearly identical message structure and source
|
||
encoding. JT65 was designed for EME ("`moonbounce`") on VHF and
|
||
higher bands and is mostly used for that purpose today. Q65 is
|
||
particularly effective for tropospheric scatter, rain scatter,
|
||
ionospheric scatter, TEP, and EME on VHF and higher bands, as well as
|
||
other types of fast-fading signals. JT9 was designed for the HF and
|
||
lower bands. Its submode JT9A is 1 dB more sensitive than JT65 while
|
||
using less than 10% of the bandwidth. JT4 offers a wide variety of
|
||
tone spacings and has proven highly effective for EME on microwave
|
||
bands up to 24 GHz. The "`slow`" modes use timed sequences of
|
||
alternating transmission and reception. JT4, JT9, and JT65 use
|
||
one-minute sequences, so a minimal QSO takes four to six minutes — two
|
||
or three transmissions by each station, one sending in odd UTC minutes
|
||
and the other even. FT8 is four times faster (15-second T/R
|
||
sequences) and less sensitive by a few dB. FT4 is faster still (7.5 s
|
||
T/R sequences) and especially well-suited for radio contesting. FST4
|
||
is designed especially for the LF and MF bands. Both FST4 and Q65
|
||
offer a wide variety of timed sequence lengths, and Q65 a range of
|
||
tone spacings for different propagation conditions. On the HF bands,
|
||
world-wide QSOs are possible with any of these modes using power
|
||
levels of a few watts (or even milliwatts) and compromise antennas.
|
||
On VHF bands and higher, QSOs are possible (by EME, scatter, and other
|
||
propagation types) at signal levels 10 to 15 dB below those required
|
||
for CW.
|
||
|
||
*MSK144*, and optionally submodes *JT9E-H* are "`fast`"
|
||
protocols designed to take advantage of brief signal enhancements from
|
||
ionized meteor trails, aircraft scatter, and other types of scatter
|
||
propagation. These modes use timed sequences of 5, 10, 15, or 30 s
|
||
duration. User messages are transmitted repeatedly at high rate (up
|
||
to 250 characters per second for MSK144) to make good use of the
|
||
shortest meteor-trail reflections or "`pings`". MSK144 uses the same
|
||
structured messages as the slow modes and optionally an abbreviated
|
||
format with hashed callsigns.
|
||
|
||
Note that some of the modes classified as slow can have T/R sequence
|
||
lengths as short the fast modes. "`Slow`" in this sense implies
|
||
message frames being sent only once per transmission. The fast modes
|
||
in _WSJT-X_ send their message frames repeatedly, as many times as
|
||
will fit into the Tx sequence length.
|
||
|
||
*WSPR* (pronounced "`whisper`") stands for **W**eak **S**ignal
|
||
**P**ropagation **R**eporter. The WSPR protocol was designed for
|
||
probing potential propagation paths using low-power transmissions.
|
||
WSPR messages normally carry the transmitting station’s callsign,
|
||
grid locator, and transmitter power in dBm, and with two-minute
|
||
sequences they can be decoded at signal-to-noise ratios as low
|
||
as -31 dB in a 2500 Hz bandwidth. *FST4W* is designed for
|
||
similar purposes, but especially for use on LF and MF bands.
|
||
It includes optional sequence lengths as long as 30 minutes and
|
||
reaches sensitivity tresholds as low as -45 dB. Users
|
||
with internet access can automatically upload WSPR and FST4W
|
||
reception reports to a central database called {wsprnet} that
|
||
provides a mapping facility, archival storage, and many other
|
||
features.
|
||
|
||
*Echo* mode allows you to detect and measure your own station's echoes
|
||
from the moon, even if they are far below the audible threshold.
|
||
|
||
_WSJT-X_ provides spectral displays for receiver passbands as wide as
|
||
5 kHz, flexible rig control for nearly all modern radios used by
|
||
amateurs, and a wide variety of special aids such as automatic Doppler
|
||
tracking for EME QSOs and Echo testing. The program runs equally well
|
||
on Windows, Macintosh, and Linux systems, and installation packages
|
||
are available for all three platforms.
|
||
|
||
*Version Numbers:* _WSJT-X_ release numbers have major, minor, and
|
||
patch numbers separated by periods: for example, _WSJT-X_ Version
|
||
2.1.0. Temporary _beta release_ candidates are sometimes made in
|
||
advance of a new general-availability release, in order to obtain user
|
||
feedback. For example, version 2.1.0-rc1, 2.1.0-rc2, etc., would
|
||
be beta releases leading up to the final release of v2.1.0.
|
||
Release candidates should be used _only_ during a short testing
|
||
period. They carry an implied obligation to provide feedback to the
|
||
program development group. Candidate releases should not be used on
|
||
the air after a full release with the same number is made.
|