mirror of https://github.com/saitohirga/WSJT-X.git
50 lines
2.3 KiB
Plaintext
50 lines
2.3 KiB
Plaintext
// Status=review
|
||
|
||
At the center of the main window are a number of controls used when
|
||
making QSOs. Controls not relevant to a particular mode or submode
|
||
may be "grayed out" (disabled) or removed from the display.
|
||
|
||
//.Misc Controls Center
|
||
image::misc-controls-center.png[align="center",alt="Misc Controls Center"]
|
||
|
||
* Check *Tx even* to transmit in even-numbered UTC minutes or
|
||
sequences, starting at 0. Uncheck this box to transmit in the odd
|
||
sequences. The correct selection is made automatically when you
|
||
double-click on a decoded text line, as described in the
|
||
<<TUTORIAL,Basic Operating Tutorial>>.
|
||
|
||
* The Tx and Rx audio frequencies can be set automatically by
|
||
double-clicking on decoded text or a signal in the waterfall. They
|
||
can also be adjusted using the spinner controls.
|
||
|
||
* You can force Tx frequency to the current Rx frequency by clicking
|
||
the *Tx<-Rx* button, and vice-versa for *Rx<-Tx*. Check the box *Lock
|
||
Tx=Rx* to make the frequencies always track one another. The
|
||
on-the-air frequency of your lowest JT9 or JT65 tone is the sum of
|
||
dial frequency and audio Tx frequency.
|
||
|
||
TIP: In general we do not recommend using *Lock Tx=Rx* since it
|
||
encourages poor radio etiquette when running a frequency. With *Lock
|
||
Tx=Rx* checked, your own Tx frequency will move around following your
|
||
callers.
|
||
|
||
* The *Report* control lets you change a signal report that has been
|
||
inserted automatically. Typical reports for the various modes fall in
|
||
the range –30 to +20 dB. Remember that JT65 reports saturate at an
|
||
upper limit of -1 dB.
|
||
|
||
TIP: Consider reducing power if your QSO partner reports your
|
||
signal above -5 dB in one of the _WSJT-X_ slow modes. These are
|
||
supposed to be weak signal modes!
|
||
|
||
* With *Split operation* activated on the *Settings -> Radio* tab, you
|
||
can activate the spinner control *Tx CQ nnn* by checking the box to
|
||
its right. The program will then generate something like `CQ nnn
|
||
K1ABC FN42` for your CQ message, where `nnn` is the kHz portion of
|
||
your current operating frequency. Your CQ message *Tx6* will then be
|
||
transmitted at the calling frequency selected in the *Tx CQ nnn* spinner
|
||
control. All other messages will be transmitted at your current
|
||
operating frequency. On reception, when you double-click on a message
|
||
like `CQ nnn K1ABC FN42` your rig will QSY to the specified frequency
|
||
so you can call the station at his specified response frequency.
|