WSJT-X/doc/source/introduction.adoc
Joe Taylor 784e246557 1. Fix a bug that could cause decoder to hang when presented with
bad data.

2. Fix a bug that could allow a Koetter-Vardy false decode instead of
a valid Berlekamp-Massey decode, sometimes leading to program crash.

3. Many more edits in the User's Guide, *.adoc files.



git-svn-id: svn+ssh://svn.code.sf.net/p/wsjt/wsjt/branches/wsjtx@3664 ab8295b8-cf94-4d9e-aec4-7959e3be5d79
2014-01-27 21:28:54 +00:00

39 lines
2.2 KiB
Plaintext
Raw Blame History

This file contains ambiguous Unicode characters

This file contains Unicode characters that might be confused with other characters. If you think that this is intentional, you can safely ignore this warning. Use the Escape button to reveal them.

// Status=review
_WSJT-X_ is a computer program designed to facilitate basic amateur
radio communication using very weak signals. The first four letters
in the program name stand for “Weak Signal communication by K1JT”, and
the “-X” suffix indicates that _WSJT-X_ started as an extended (and
experimental) branch of program _WSJT_.
_WSJT-X_ offers two protocols or “modes,” JT65 and JT9. Both are
designed for making reliable, confirmed QSOs under extreme weak-signal
conditions. They use nearly identical message structure and source
encoding. JT65 was designed for EME (“moon-bounce”) on the VHF/UHF
bands, and has also proved very effective for worldwide QRP
communication at HF. JT9 is optimized for the LF, MF, and HF bands.
It is about 2 dB more sensitive than JT65 while using less than 10% of
the bandwidth. Both modes use one-minute timed sequences of
alternating transmission and reception, so a minimal QSO takes four to
six minutes — two or three transmissions by each station, one sending
in odd UTC minutes and the other even. World-wide QSOs are possible
with power levels of a few watts and compromise antennas.
_WSJT-X_ can display a bandpass as large as 5 kHz and transparently
provides dual-mode reception of both JT65 and JT9 signals. If your
receiver can be configured with at least 4 kHz bandwidth in USB mode,
you can set the dial frequency to one of the standard JT65 frequencies
— for example, 14.076 MHz for the 20-meter band — and display the full
JT65 and JT9 sub-bands simultaneously on the waterfall. You can then
make QSOs in both modes using nothing more than mouse clicks.
Plans for future program development call for _WSJT-X_ and _WSJT_ to
merge together. _WSJT-X_ will gradually acquire the additional modes
JT4, FSK441, and ISCAT that are now supported in _WSJT_. The entire
WSJT-related effort is an open-source project. If you have
programming or documentation skills or would like to contribute to the
project in other ways, please make your interests known to the
development team. The projects source-code repository can be found
at {devsvn}, and communication among the developers takes place on the
email reflector {devmail}.