Clean up our record of the active streams in shutdown(), fixing
subsequent failures of snd_pcm_hw_constraints_complete after closure of
a stream.
NOTE:
- The ssm2602 allows pairs of non-matching PB/REC rates.
- This is a fix for less evil:
The logic is flawed (e.g. the slave might startup before the
master's rate and sample_bits are set).
Signed-off-by: Karl Beldan <karl.beldan@gmail.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
One of the issues with the ASoC v1 API which has been addressed in the
ASoC v2 work that Liam Girdwood has done is that the ALSA card provided
by ASoC is distributed around the ASoC structures. For example, machine
wide data such as the struct snd_card are maintained as part of the
CODEC data structure, preventing the use of multiple codecs. This has
been addressed by refactoring the data structures so that all the data
for the ALSA card is contained in a single structure snd_soc_card which
replaces the existing snd_soc_machine and snd_soc_device.
Begin the process of backporting this by renaming struct snd_soc_machine
to struct snd_soc_card, better reflecting its function and bringing it
closer to standard ALSA terminology.
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
This patch adds twl4030 audio support on omap2evm
Signed-off-by: Arun KS <arunks@mistralsolutions.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
The PCM3008 is used on the Lyrtech SFFSDR board, in conjunction with an
FPGA that generates the bit clock and the master clock
[Downgraded the rate debug print to pr_debug() in hw_params, converted
asm/gpio.h to linux/gpio.h -- broonie]
Signed-off-by: Hugo Villeneuve <hugo@hugovil.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
The PCM3008 is a 16-bit stereo audio codec. It accepts
left-justified format for ADC, and right-justified format
for DAC. Independent power-down modes for ADC and DAC are
provided, as well as a digital de-emphasis filter (4 modes).
[Merged Makefile & Kconfig, changed asm/gpio.h to linux/gpio.h -- broonie]
Signed-off-by: Hugo Villeneuve <hugo@hugovil.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Cc: Cliff Cai <cliff.cai@analog.com>
Signed-off-by: Mike Frysinger <vapier.adi@gmail.com>
Signed-off-by: Bryan Wu <cooloney@kernel.org>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Cc: Cliff Cai <cliff.cai@analog.com>
Signed-off-by: Mike Frysinger <vapier.adi@gmail.com>
Signed-off-by: Bryan Wu <cooloney@kernel.org>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
A probe function should have a clean return 0 path.
Cc: Cliff Cai <cliff.cai@analog.com>
Signed-off-by: Michael Hennerich <michael.hennerich@analog.com>
Signed-off-by: Bryan Wu <cooloney@kernel.org>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
clean up redudent code and correct building problem in non-mmap mode
Signed-off-by: Cliff Cai <cliff.cai@analog.com>
Signed-off-by: Bryan Wu <cooloney@kernel.org>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
This patch provides a option for users to enable multi-channel function support
in Blackfin ASoC driver. Because Blackfin is without MMU, it is easy for us and
the user to enable this function at compiling stage not dynamically on the fly.
Signed-off-by: Cliff Cai <cliff.cai@analog.com>
Signed-off-by: Bryan Wu <cooloney@kernel.org>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
We added multi-channel function to this codec driver and Blackfin ASoC driver as well.
It was tested on Blackfin hardware.
Signed-off-by: Cliff Cai <cliff.cai@analog.com>
Signed-off-by: Bryan Wu <cooloney@kernel.org>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
tweak SPORT range for non-BF54x so we get proper behavior for BF52x parts
Signed-off-by: Mike Frysinger <vapier.adi@gmail.com>
Signed-off-by: Bryan Wu <cooloney@kernel.org>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Fix concurrent capture/playback issue.
The issue is caused by re-initialization of control registers used specifically
for capture or playback in both capture and playback operations.
Signed-off-by: Steve Chen <schen@mvista.com>
Signed-off-by: Naresh Medisetty <naresh@ti.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
A small additional power saving can be achieved for the WM8990 by
maintaining VMID using a 2*250k divider when in standby mode.
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Enable a hardware workaround which avoids problems with the clocking of
the ADCs in certain configurations.
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Only fully documented registers are cached in the WM8990 but additional
registers exist.
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
FGAIN for playback is in range of 0-0x3f, while for capture GAIN it
is in the range of 0-0x1f.
The original value of 128 (0x7f) would modify the CGAIN also for
playback.
Signed-off-by: Peter Ujfalusi <peter.ujfalusi@nokia.com>
Acked-by: Steve Sakoman <steve@sakoman.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
The WM8728 is a high performance stereo DAC designed for applications
such as DVD, home theatre and digital TV.
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
This reverts commit 8dc840f88d. Christian
Pellegrin <chripell@gmail.com> reported that on some systems the patch
caused DMA to fail which is much more serious than the original skipped
audio issue. Further investigation by Dave shows that the behaviour
depends on the clock speed of the SoC - a better fix is neeeded.
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Originally it was put too tight limits to support only 44.1 kHz and 48 kHz
sample rates in McBSP DAI driver. Extend it now to 8 kHz - 96 kHz. With
96 kHz and 2*16 bits, bit clock is 3.072 MHz < 3.125 MHz (I2S max?).
Tested on Nokia N810 with TVL320AIC33 from rates 8 - 96 kHz and on Texas
Instruments Beagle with TWL4030 from rates 8 - 48 kHz.
Signed-off-by: Jarkko Nikula <jarkko.nikula@nokia.com>
Acked-by: Steve Sakoman <steve@sakoman.com>
Acked-by: Arun KS <arunks@mistralsolutions.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
TWL4030 currently supports rates between 8 kHz and 48 kHz and sets the codec
mode register accordingly in twl4030_hw_params. Expose this info so that
ASoC can match other rates than 44.1 kHz or 48 kHz as well.
Signed-off-by: Jarkko Nikula <jarkko.nikula@nokia.com>
Acked-by: Steve Sakoman <steve@sakoman.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Fixes swapping of channels at start of stereo playback.
Channel swap can be observed while playing left-only or right-only audio data. The channel
swap is fixed by handling the XSYNCERR condition.
Signed-off-by: Naresh Medisetty <naresh@ti.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
The TI DVEVM board uses the SND_SOC_DAIFMT_CBM_CFM & I2S formats, but the
Lyrtech SFFSDR board uses the SND_SOC_DAIFMT_CBM_CFS & RIGHT-JUSTIFIED formats.
Signed-off-by: Hugo Villeneuve <hugo.villeneuve@lyrtech.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
fixes playing/recording of 8 bit audio files.
Generated on 20081108 against v2.6.27
Signed-off-by: Christian Pellegrin <chripell@fsfe.org>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Add support for more sample rates, different crystals
and split playback/capture rates.
Signed-off-by: Troy Kisky <troy.kisky@boundarydevices.com>
Acked-by: Arun KS <arunks@mistralsolutions.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
According to TRM, 256*Fs clock output should be enabled
when TWL4030 is in slave mode, not master.
This allows sound to work on OMAP3 Pandora, which uses
256*Fs clock.
Signed-off-by: Grazvydas Ignotas <notasas@gmail.com>
Acked-by: Steve Sakoman <steve@sakoman.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
The S3C24xx dma does not allow more than one buffer to be enqueue prior to
the dma transfers starting. This patch adds an additional parameter to
s3c24xx_pcm_enqueue() to allow for passing an initial dma maximum load
value.
Signed-off-by: David Anders <danders at amltd.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Rather than try to remember to keep the core version number updated
(which hasn't been happening) just remove it. It was much more useful
when ASoC was out of tree.
Signed-off-by: Mark brown <broonie@opensource.wolfsonmicro.com>
this patch adds asoc audio driver for pxa27x based Palm PDAs. I tested it for
palmtx, t5 and ld, it should work with palmz72 as well (slapin, please test).
I sent it here some time ago, but now I got to fixing bugs in it. It should
be somehow mostly ok and ready for applying.
[Converted to use snd_soc_dapm_nc_pin() and bool Kconfig -- broonie]
Signed-off-by: Marek Vasut <marek.vasut@gmail.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
The file(s) below do not use LINUX_VERSION_CODE nor KERNEL_VERSION.
sound/soc/codecs/ad73311.c
This patch removes the said #include <version.h>.
Signed-off-by: Huang Weiyi <weiyi.huang@gmail.com>
Acked-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Call device_create_file only once in snd_soc_dapm_sys_add function.
Signed-off-by: Troy Kisky <troy.kisky@boundarydevices.com>
Acked-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
Add audio support for the Atmel AT91SAM9G20ek board(uing wolfson 8731).
It is based on the former eti_b1_wm8731.c file, using the atmel scc API.
Signed-off-by: Sedji Gaouaou <sedji.gaouaou@atmel.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
The Ateml AT91 and AVR32 SoC share common IP for audio and can share the
same driver code using the atmel-ssc API provided for both architectures.
Do this, creating a new unified atmel ASoC architecture to replace the
previous at32 and at91 ones.
[This was contributed as a patch series for reviewability but has been
squashed down to a single commit to help preserve both the history and
bisectability. A small bugfix from Jukka is included.]
Tested-by: Jukka Hynninen <ext-jukka.hynninen@vaisala.com>
Signed-off-by: Sedji Gaouaou <sedji.gaouaou@atmel.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
sound/soc/soc-dapm.c: In function 'snd_soc_dapm_sys_add':
sound/soc/soc-dapm.c:828: error: 'ret' undeclared (first use in this function)
Signed-off-by: Stephen Rothwell <sfr@canb.auug.org.au>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
