android_kernel_xiaomi_sm8350/arch/x86/mm/ioremap_64.c
Christoph Lameter b263295dbf x86: 64-bit, make sparsemem vmemmap the only memory model
Use sparsemem as the only memory model for UP, SMP and NUMA.  Measurements
indicate that DISCONTIGMEM has a higher overhead than sparsemem.  And
FLATMEMs benefits are minimal.  So I think its best to simply standardize
on sparsemem.

Results of page allocator tests (test can be had via git from slab git
tree branch tests)

Measurements in cycle counts. 1000 allocations were performed and then the
average cycle count was calculated.

Order	FlatMem	Discontig	SparseMem
0	  639	  665		  641
1	  567	  647		  593
2	  679	  774		  692
3	  763	  967		  781
4	  961	 1501		  962
5	 1356	 2344		 1392
6	 2224	 3982		 2336
7	 4869	 7225		 5074
8	12500	14048		12732
9	27926	28223		28165
10	58578	58714		58682

(Note that FlatMem is an SMP config and the rest NUMA configurations)

Memory use:

SMP Sparsemem
-------------

Kernel size:

   text    data     bss     dec     hex filename
3849268  397739 1264856 5511863  541ab7 vmlinux

             total       used       free     shared    buffers     cached
Mem:       8242252      41164    8201088          0        352      11512
-/+ buffers/cache:      29300    8212952
Swap:      9775512          0    9775512

SMP Flatmem
-----------

Kernel size:

   text    data     bss     dec     hex filename
3844612  397739 1264536 5506887  540747 vmlinux

So 4.5k growth in text size vs. FLATMEM.

             total       used       free     shared    buffers     cached
Mem:       8244052      40544    8203508          0        352      11484
-/+ buffers/cache:      28708    8215344

2k growth in overall memory use after boot.

NUMA discontig:

   text    data     bss     dec     hex filename
3888124  470659 1276504 5635287  55fcd7 vmlinux

             total       used       free     shared    buffers     cached
Mem:       8256256      56908    8199348          0        352      11496
-/+ buffers/cache:      45060    8211196
Swap:      9775512          0    9775512

NUMA sparse:

   text    data     bss     dec     hex filename
3896428  470659 1276824 5643911  561e87 vmlinux

8k text growth. Given that we fully inline virt_to_page and friends now
that is rather good.

             total       used       free     shared    buffers     cached
Mem:       8264720      57240    8207480          0        352      11516
-/+ buffers/cache:      45372    8219348
Swap:      9775512          0    9775512

The total available memory is increased by 8k.

This patch makes sparsemem the default and removes discontig and
flatmem support from x86.

[ akpm@linux-foundation.org: allnoconfig build fix ]

Acked-by: Andi Kleen <ak@suse.de>
Signed-off-by: Christoph Lameter <clameter@sgi.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
2008-01-30 13:30:47 +01:00

194 lines
5.3 KiB
C

/*
* arch/x86_64/mm/ioremap.c
*
* Re-map IO memory to kernel address space so that we can access it.
* This is needed for high PCI addresses that aren't mapped in the
* 640k-1MB IO memory area on PC's
*
* (C) Copyright 1995 1996 Linus Torvalds
*/
#include <linux/vmalloc.h>
#include <linux/init.h>
#include <linux/slab.h>
#include <linux/module.h>
#include <linux/io.h>
#include <asm/pgalloc.h>
#include <asm/fixmap.h>
#include <asm/tlbflush.h>
#include <asm/cacheflush.h>
#include <asm/proto.h>
unsigned long __phys_addr(unsigned long x)
{
if (x >= __START_KERNEL_map)
return x - __START_KERNEL_map + phys_base;
return x - PAGE_OFFSET;
}
EXPORT_SYMBOL(__phys_addr);
#define ISA_START_ADDRESS 0xa0000
#define ISA_END_ADDRESS 0x100000
/*
* Fix up the linear direct mapping of the kernel to avoid cache attribute
* conflicts.
*/
static int
ioremap_change_attr(unsigned long phys_addr, unsigned long size,
unsigned long flags)
{
int err = 0;
if (phys_addr + size - 1 < (end_pfn_map << PAGE_SHIFT)) {
unsigned long npages = (size + PAGE_SIZE - 1) >> PAGE_SHIFT;
unsigned long vaddr = (unsigned long) __va(phys_addr);
/*
* Must use a address here and not struct page because the phys addr
* can be a in hole between nodes and not have an memmap entry.
*/
err = change_page_attr_addr(vaddr,npages,__pgprot(__PAGE_KERNEL|flags));
if (!err)
global_flush_tlb();
}
return err;
}
/*
* Generic mapping function
*/
/*
* Remap an arbitrary physical address space into the kernel virtual
* address space. Needed when the kernel wants to access high addresses
* directly.
*
* NOTE! We need to allow non-page-aligned mappings too: we will obviously
* have to convert them into an offset in a page-aligned mapping, but the
* caller shouldn't need to know that small detail.
*/
void __iomem * __ioremap(unsigned long phys_addr, unsigned long size, unsigned long flags)
{
void * addr;
struct vm_struct * area;
unsigned long offset, last_addr;
pgprot_t pgprot;
/* Don't allow wraparound or zero size */
last_addr = phys_addr + size - 1;
if (!size || last_addr < phys_addr)
return NULL;
/*
* Don't remap the low PCI/ISA area, it's always mapped..
*/
if (phys_addr >= ISA_START_ADDRESS && last_addr < ISA_END_ADDRESS)
return (__force void __iomem *)phys_to_virt(phys_addr);
pgprot = __pgprot(_PAGE_PRESENT | _PAGE_RW | _PAGE_GLOBAL
| _PAGE_DIRTY | _PAGE_ACCESSED | flags);
/*
* Mappings have to be page-aligned
*/
offset = phys_addr & ~PAGE_MASK;
phys_addr &= PAGE_MASK;
size = PAGE_ALIGN(last_addr+1) - phys_addr;
/*
* Ok, go for it..
*/
area = get_vm_area(size, VM_IOREMAP | (flags << 20));
if (!area)
return NULL;
area->phys_addr = phys_addr;
addr = area->addr;
if (ioremap_page_range((unsigned long)addr, (unsigned long)addr + size,
phys_addr, pgprot)) {
remove_vm_area((void *)(PAGE_MASK & (unsigned long) addr));
return NULL;
}
if (flags && ioremap_change_attr(phys_addr, size, flags) < 0) {
area->flags &= 0xffffff;
vunmap(addr);
return NULL;
}
return (__force void __iomem *) (offset + (char *)addr);
}
EXPORT_SYMBOL(__ioremap);
/**
* ioremap_nocache - map bus memory into CPU space
* @offset: bus address of the memory
* @size: size of the resource to map
*
* ioremap_nocache performs a platform specific sequence of operations to
* make bus memory CPU accessible via the readb/readw/readl/writeb/
* writew/writel functions and the other mmio helpers. The returned
* address is not guaranteed to be usable directly as a virtual
* address.
*
* This version of ioremap ensures that the memory is marked uncachable
* on the CPU as well as honouring existing caching rules from things like
* the PCI bus. Note that there are other caches and buffers on many
* busses. In particular driver authors should read up on PCI writes
*
* It's useful if some control registers are in such an area and
* write combining or read caching is not desirable:
*
* Must be freed with iounmap.
*/
void __iomem *ioremap_nocache (unsigned long phys_addr, unsigned long size)
{
return __ioremap(phys_addr, size, _PAGE_PCD);
}
EXPORT_SYMBOL(ioremap_nocache);
/**
* iounmap - Free a IO remapping
* @addr: virtual address from ioremap_*
*
* Caller must ensure there is only one unmapping for the same pointer.
*/
void iounmap(volatile void __iomem *addr)
{
struct vm_struct *p, *o;
if (addr <= high_memory)
return;
if (addr >= phys_to_virt(ISA_START_ADDRESS) &&
addr < phys_to_virt(ISA_END_ADDRESS))
return;
addr = (volatile void __iomem *)(PAGE_MASK & (unsigned long __force)addr);
/* Use the vm area unlocked, assuming the caller
ensures there isn't another iounmap for the same address
in parallel. Reuse of the virtual address is prevented by
leaving it in the global lists until we're done with it.
cpa takes care of the direct mappings. */
read_lock(&vmlist_lock);
for (p = vmlist; p; p = p->next) {
if (p->addr == addr)
break;
}
read_unlock(&vmlist_lock);
if (!p) {
printk("iounmap: bad address %p\n", addr);
dump_stack();
return;
}
/* Reset the direct mapping. Can block */
if (p->flags >> 20)
ioremap_change_attr(p->phys_addr, p->size, 0);
/* Finally remove it */
o = remove_vm_area((void *)addr);
BUG_ON(p != o || o == NULL);
kfree(p);
}
EXPORT_SYMBOL(iounmap);